JVC 1108TTH-AO-AO, PB006585599-1, DLA-RS0 manual Standby/On, Time Frequency

ENGLISH

About Warning Indicators

The accumulated lamp time or warning mode of this unit is displayed by the indicators.

For information on indicator display during normal operation, see “Controls and Features”. (P14)

		Indicator		Blinking	Blinking	Interval
No. WARNING						between		Content
		LAMP	STANDBY/ON	Time	Frequency
						Blinks
1	-	-	Light on (Red)	-	-	-	During standby
2	-	-	Light on	-	-	-	When the power on		Indicator
			(Green)				(Hide Off)
									display
			Blinking	0.5			When the power on
3	-	-			continuous	-			in normal
			(Green)	second			(Hide On)
									conditions.
	-	-		0.5		-
4			Blinking (Red)		continuous		During cool down
				second
							Lamp replacement is near (		P48 to 50)
5	-	Light on	-	-	-	-
							(When accumulated lamp time has
		(orange)
							exceeded 1900 hours)
							Lamp has reached the end of life
6	-	Light on	-	-	-	-	(	P48 to 50)
		(orange)					(When accumulated lamp time has
							exceeded 2000 hours)
7				0.25	1 time	0.75	Lamp does not light up and unit is
				second		second	unable to project
	Light on	Blinking
8			-	0.25	2 times	0.75	Lamp is turned off during projection
	(Red)	(orange)		second		second
9				0.25	3 times	0.75	Lamp cover is removed
				second		second
10				0.25	1 time	0.75	Abnormalities in the power supply
				second		second
11				0.25	2 times	0.75	Cooling fan stops
				second		second	(cooling fan gets caught)
		-
12				0.25	3 times	0.75	Internal temperature is too high
				second		second	(abnormal internal temperature)
13				0.25	4 times	0.75	External temperature is too high
	Blinking			second		second	(abnormal external temperature)
			-
				0.25		0.75	Abnormal electrical circuit
14	(Red)				1 time
				second		second	(abnormal startup of drive circuit)
				0.25		0.75	Abnormal electrical circuit
15					2 times		(abnormal communication of the
		Blinking		second		second
							drive circuit)
16		(orange)		0.25	3 times	0.75	Abnormal electrical circuit
				second		second	(abnormal drive circuit of image)
17				0.25	4 times	0.75	Abnormalities in the automatic lens cover
				second		second

Actions to Be Taken for Warning Mode

When the unit enters into warning mode (No. 7 to 17), it will automatically stop projection, and run the cooling fan for about 60 seconds.

After the cooling fan has stopped, pull out the power plug from the power outlet. Then, follow the procedures below.

No.	Check	Action
7	● Check that an impact shock has not occurred during operation.
8
	● Check that the lamp unit and lamp cover are correctly installed.	Turn on the power again.
9
	● Check that nothing is blocking the auto lens cover.
17
10
11
12	● Check that nothing is blocking the air inlets.	Leave the unit until it cools down.
13
	● Check that the external temperature is normal.	After that, turn on the power again.
14
15
16

If the warning indication is displayed again, please wait for the cooling fan stopped, then pull out the power plug from the power outlet. Then call your authorized dealer for repair.

Getting Started

Preparation

Basic Operation

Settings

Troubleshooting

Others

47