Onkyo HT-RC270 About AV Connections, Connected image with AV components, AV Cables and Jacks

Page 17
About AV Connections

About AV Connections

Connected image with AV components

HDMI cable

 

: Video & Audio

 

AV receiver

 

Blu-ray Disc/

 

TV, projector, etc.

DVD player

Game console

 

Other cables

 

: Video

 

: Audio

 

 

AV receiver

 

Blu-ray Disc/

 

TV, projector, etc.

DVD player

Game console

 

•Before making any AV connections, read the manuals supplied with your AV components.

•Don’t connect the power cord until you’ve completed and double-checked all AV connections.

•Push plugs in all the way to make good connections (loose connections can cause noise or malfunc- tions).

•To prevent interference, keep audio and video cables away from power cords and speaker cables.

Connected image with AV components Right!

AV Cables and Jacks Wrong!

AV Cables and Jacks

Signal

Cable

 

Jack

Description

Video and

HDMI

 

HDMI

HDMI connections can carry digital video and audio.

Audio

 

 

 

 

Video

Component video

Y

Green

Component video separates the luminance (Y) and color

 

 

difference signals (PB/CB, PR/CR), providing the best pic-

 

 

PB/CB

 

 

 

Blue

ture quality (some TV manufacturers label their compo-

 

 

PR/CR

Red

nent video sockets slightly differently).

 

 

 

 

Analog RGB

 

 

This is a conventional analog interface to connect a PC and

 

 

 

 

a display device (also called D-Sub or D-subminiature).

 

S-Video

 

 

S-Video separates the luminance and color signals and pro-

 

 

 

 

vides better picture quality than composite video.

Composite video

V

Yellow

Composite video is commonly used on TVs, VCRs, and

other video equipment.

 

 

Audio

Optical digital

 

audio

OPTICAL

Optical digital connections allow you to enjoy digital

 

 

 

sound such as PCM*, Dolby Digital or DTS. The audio

 

 

 

quality is the same as coaxial.

 

 

 

Coaxial digital

Orange

Coaxial digital connections allow you to enjoy digital

audio

sound such as PCM*, Dolby Digital or DTS. The audio

 

 

quality is the same as optical.

Analog audio (RCA)

L

R

White

Analog audio connections (RCA) carry analog audio.

 

Red

 

1/8" (3.5 mm)

This cable carries analog audio.

Stereo mini plug

 

Multichannel ana- log audio (RCA)

This cable carries multichannel analog audio and is typi- cally used to connect DVD players with a 7.1-channel ana- log audio output. Several standard analog audio cables can be used instead of a multichannel cable.

*Available sampling rate for PCM input signal is 32/44.1/48/88.2/96 kHz. Even 176.4/192 kHz is effective in case of the HDMI con- nection.

Note

• The AV receiver does not support SCART plugs.

• The AV receiver’s optical digital jacks have shutter-type covers that open when an optical plug is inserted and close when it’s removed. Push plugs in all the way.

Caution

En

• To prevent shutter damage, hold the optical plug straight when inserting and removing.

17

 

Page 16 Page 18
Image 17
Page 16 Page 18
Contents HT-RC270 ContentsInstruction Manual AV ReceiverImportant Safety Instructions AVISFor U.S. models PrecautionsFor Canadian Models Modèle pour les CanadienUsing the Remote Controller Supplied AccessoriesInstalling the Batteries Aiming the Remote ControllerIntroduction ContentsConnections Turning On & Basic OperationsAmplifier FeaturesProcessing MiscellaneousTHX Select2 Plus b cdefg Front & Rear Panelsij klm n o p u v w x ya b c Displayd e f k l mna bcd Controlling the AV Receiver Remote ControllerEnjoying Home Theater About Home Theaterij kl de ghConnecting Your Speakers Connecting the AV ReceiverSpeaker Configuration Speaker Connection Precautionswires tightly, as shown Connecting the Speaker CablesUsing Banana Plugs Screw-typespeaker terminalsConnecting a Powered Subwoofer Using Dipole SpeakersBi-ampingthe Front Speakers Connecting a Power AmplifierPower amplifier RightLeft speakerspeakerAV Cables and Jacks About AV ConnectionsConnected image with AV components Audio return channel ARC function Connecting Your Components with HDMIdisplay when changing settings Connecting Your ComponentsHow to record the video Connecting Onkyo uComponentsRemote Control Direct ChangeInsert wire Connecting AntennaInsert the plug fully into the jack PushSignal Selection Which Connections Should I Use?Video Connection Formats Audio Connection Formats Turning Off Turning On/Off the AV ReceiverTurning On Basic Operations Setting the Display BrightnessPlaying the Connected Component Displaying Source InformationUsing the Sleep Timer Using the Home MenuMuting the AV Receiver Selecting Speaker LayoutChanging the Input Display Using HeadphonesRestoring Default Using Easy MacrosTurning Off the Components Changing Source ComponentUsing Audyssey MultEQ Audyssey MultEQ Room Correction and Speaker SetupFirst measurement position Second−Sixth measurement positions7 When prompted, repeat step 3 When you’ve finished making the settings, press`Cancel 9 Disconnect the speaker setup microphoneChanging the Speaker Settings Manually Error MessagesUsing a Powered Subwoofer `CancelTuning into Radio Stations Using the TunerListening to the Radio Listening to the RadioSelecting Presets Presetting FM/AM StationsDeleting Presets MODERecording Connecting a Recording ComponentRecording Separate AV Sources AV RecordingSelecting Listening Modes Using the Listening ModesListening Mode Buttons PURE AUDIO button and indicatorExplanatory Notes About Listening ModesInput Source Speaker LayoutDolby PLIIx Movie Listening Modes• Dolby PLIIx Music • Dolby PLIIx Game• Neo:6 Music Listening Mode• Neo:6 Cinema • THX Music • THX Cinema• THX Games THX Select2 CinemaUse this mode when playing action game discs Onkyo-OriginalDSP Listening ModesUse this mode when playing rock game discs Use this mode when playing sports game discsOn-screenSetup Menus Advanced SetupCommon Procedures in Setup Menu c 3. Audio Adjust d 4. Source SetupMonitor Out Input/Output AssignHDMI Input ResolutionDigital Audio Input Component Video InputAnalog Audio Input BD/DVD, VCR/DVR, CBL/SAT, GAME, PC, AUXSpeaker Settings Speaker SetupSpeaker Configuration Powered Zone2Level Calibration Speaker DistanceSurr Back Ch LPF of LFE Low-PassFilter for the LFE ChannelTHX Audio Setup Equalizer SettingsEqualizer Surr Back Speaker SpacingMultiplex/Mono Audio AdjustDolby Preserve THX SettingsTheater-Dimensional Source SetupAudyssey DSX LFE LevelReference Level Dynamic VolumeAudyssey Dynamic EQ Reference Level Offset `0dB `5dBA/V Sync IntelliVolumeName Edit IntelliVolumeGame Mode Picture AdjustWide Mode*1*2 Picture Mode*1*2Edge Enhancement*2 Listening Mode PresetNoise Reduction*2 Brightness*1*2Volume Setup Hardware SetupOSD Setup MiscellaneousAudio TV Out HDMILip Sync HDMI Control RIHDFirmware Update Auto Power DownNetwork Power ControlUsing the Audio Settings Lock SetupTone Control Settings SetupSpeaker Levels Audyssey SettingsMusic Optimizer Late NightAudio Selector Setting the Incoming Digital Signal Fixed ModeAudio Selector NET/USB Connecting the AV ReceiverAbout NET Network RequirementsListening to vTuner Internet Radio Listening to Internet RadioListening to Other Internet Radio ENTERPlaying Music Files on a Server Registering Presets*1Station and Song Presets Items on the Internet Radio Top MenuSupported Audio File Formats Windows Media Player 11 SetupAbout DLNA Server RequirementsWMA Lossless FLACUsing Remote Playback Windows Media Player 12 SetupSupported Music File Formats Server RequirementsENTER Network SettingsMac Address DHCPUSB Mass Storage Device Requirements About USBPlaying Music Files on a USB Device Supported Audio File Formatsreceiver’s USB port Plug your USB mass storage device into the AVPress NET/USB repeatedly to select the “USB” inputZone Connecting ZoneConnecting Your Zone 2 Speakers to an Amp in Zone Using Zone Setting the Powered ZoneControlling Zone 2 from the AV receiver ENTERAdjusting the Volume for Zone Controlling Zone 2 with the Remote ControllerMuting Zone Operating with the remote controllerConnecting the iPod Directly to the USB Port Playing Music Files on the iPod/iPhone3 Press DISPLAY to switch to Extended Mode*3 ENTERConnecting an Onkyo Dock UP-A1Dock Using the Onkyo DockUsing Your iPod models Alarm Clock Charging Your iPod models BatteryRI Dock Controlling Your iPodWithout the RI Control With the RI ControlStandard mode g h i bj c k d eExtended mode Music Extended mode VideoLooking up for Remote Control Code Preprogrammed Remote Control CodesControlling Other Components ENTERENTER Entering Remote Control CodesENTER REMOTE MODE • BD/DVD `31612Resetting the Remote Controller Resetting REMOTE MODE ButtonsControlling Other Components Controlling a TVai a j k b cl d em f g h n Deleting Learning Commands Learning CommandsUsing Normal Macros Deleting Macros Making MacrosRunning Macros Press MY MOVIE, MY TV, or MY MUSICPower TroubleshootingAudio The STANDBY indicator flashes redAbout DTS signals There’s no sound with a certain signal formatOnly the front speakers produce sound Only the center speaker produces soundVideo Remote ControllerTuner The remote controller doesn’t workZone RecordingMusic Server and Internet Radio USB Mass Storage Device PlaybackThe ufunctions don’t work Video ATT:OFF: default• Video Attenuation CBL/SAT, GAME, or AUX inputAmplifier Section SpecificationsGeneral Video SectionAbout Copyright Protection About HDMISupported Audio Formats About p-compatiblecomponents Using an RIHD-compatibleTV, Player, or Recorder1Confirm the connecting and setting How to connect and setup•Power Control: On •TV Control: On 3 Confirm the settingsOutput Video Resolution ChartNTSC/PAL ONKYO U.S.A. CORPORATION 2 9 4 0 0 3 5ONKYO EUROPE ELECTRONICS GmbH ONKYO EUROPE ELECTRONICS GmbH UK BRANCH
Top Page Image Contents