Onkyo HT-RC270 Advanced Setup, On-screenSetup Menus, Common Procedures in Setup Menu

Advanced Setup

On-screen Setup Menus

The on-screen setup menus appear only on a TV that is connected to the HDMI OUT. If your TV is con-

nected to the MONITOR OUT V, MONITOR OUT S

or the COMPONENT VIDEO MONITOR OUT, use the AV receiver’s display when changing settings.

This manual describes the procedure using the remote controller unless otherwise specified.

Common Procedures in Setup Menu

RECEIVER

ENTER

q/w/e/r

SETUP RETURN

MENU

a1. Input/Output Assign b 2. Speaker Setup

c 3. Audio Adjust d 4. Source Setup

e 5. Listening Mode Preset f 6. Miscellaneous

g 7. Hardware Setup

h 8. Remote Controller Setup i 9. Lock Setup

a Input/Output Assign		f Miscellaneous
(➔ 42)		(➔ 53)
	1. Input/Output Assign		6. Miscellaneous
1.	Monitor Out	1.	Volume Setup
2.	HDMI Input	2.	OSD Setup

3.Component Video Input

4.Digital Audio Input

5.Analog Audio Input

b Speaker Setup			g Hardware Setup
	(➔ 44)		(➔ 53)
				7. Hardware Setup
		2. Speaker Setup
1.		Speaker Settings	1.	Remote ID
2.		Speaker Configuration	2.	Tuner
3.		Speaker Distance	3.	HDMI
4.		Level Calibration	4.	Auto Power Down
5.		Equalizer Settings	5.	Network
6.		THX Audio Setup	6.	Firmware Update
c Audio Adjust			h Remote Controller
	(➔ 47)		Setup (➔ 76)
		3. Audio Adjust		8. Remote Controller Setup
1.		Multiplex/Mono	Remote Mode Setup

2.Dolby

3.DTS

4.Audyssey DSX

5.Theater-Dimensional

6.LFE Level

d Source Setup (➔ 48)	i Lock Setup (➔ 56)
4. Source Setup	9. Lock Setup
1. Audyssey	Setup

2.IntelliVolume

3.A/V Sync

4.Name Edit

5.Picture Adjust

eListening Mode Preset (➔ 52)

5.Listening Mode Preset

1.BD/DVD

2.VCR/DVR

3.CBL/SAT

4.GAME

5.PC

6.AUX

The on-screen setup menus appear on the connected TV and provide a convenient way to change the AV receiver’s various settings. Settings are organized into 9 categories on the main menu.

Carry out the settings by using the on-screen display.

1 Press RECEIVER followed by SETUP. The following menu appears.

MENU

1. Input/Output Assign

2. Speaker Setup

3. Audio Adjust

4. Source Setup

5. Listening Mode Preset

6. Miscellaneous

7. Hardware Setup

8. Remote Controller Setup

9. Lock Setup

Tip

• If the main menu doesn’t appear, make sure the appropri- ate external input is selected on your TV.

2 Use q/wto select a menu, and then press ENTER.

3 Use q/wto select target and then press ENTER.

4 Use q/wto select option and use e/rto change the setting.

Press SETUP to close the menu.

Press RETURN to return to the previous menu.

Note

•This procedure can also be performed on the AV receiver by using SETUP, arrow buttons, and ENTER.

•During Audyssey MultEQ® Room Correction and Speaker Setup, messages, etc., that are displayed on the TV screen will appear in the Display.

En

41