McIntosh MDLP1 owner manual Screen

Page 15
Figure 13

Initial Setup

Screen

Figure 8

Screen

Figure 9

centered vertically on the screen the Crosshatch Test Pattern lines are again white in color.

9.Using the Knurled Ring surfaces on the projector lens adjust the size and focus of the image. Refer to figure 7.

10.Rotate one or both of the projector feet to line up the top and bottom horizontal lines of the Crosshatch Test Pattern to be parallel with the top and bottom edges of the screen. Refer to figures 5 and 10.

Figure 10

Note: If more than several turns are needed there is a release lever located next to the foot for rapid and large changes in height. Refer to figure 11.

Figure 11

11.Using the Knurled Ring surfaces on the projector lens adjust the size and focus of the image. Refer to figure 7.

12.Rotate the projector clockwise or counterclockwise

about the center horizontal axis to minimize any horizontal keystone distortion. The top and bottom horizontal lines of the Crosshatch Test Pattern should be parallel with the top and bottom edges of the screen. Refer to figures 5, 12 and 13.

13. Using the knurled

 

ring surfaces on

 

the projector lens

 

to adjust the size

 

and focus of the

 

image. Refer to

 

figure 7.

������

14. Repeat steps 6 thru

 

13 until no further

 

improvements can

 

be made.

 

Note: Correction

 

for any

 

vertical

 

keystone

Figure 12

distortion

 

of the im-

 

age will be

 

performed

 

later during

 

the elec-

 

tronic setup

������

adjustments

 

on page 23.

 

15. Press the STAND-

BY/ON Push- button on the Projector Control Panel or the PROJ ON Push-button using the Remote Control.

16.Temporarily place the previously removed protective cover onto the projector lens.

17.Remove the AC Power Cord from the projector.

18.Proceed to the “How to connect the MDLP1” on page 17.

15

Image 15
Contents Video Projector Important Safety Instructions Safety Instructions Additional Safety InstructionsPlease Take a Moment Customer ServiceTable of Contents Thank YouGeneral Information RS232 DB9 Connector Pin Layout Connector and Cable InformationPower Control Connectors Data Port ConnectorsPerformance Features Dimensions Ventilation Installation Installation OverviewProjector and 169 Screen Mounting Location Projector mounted from the ceilingProjector placed above the floor Installation, con’t Projector and 43 Screen Mounting Location Installation, con’t Initial Setup Screen Rear Panel Connections and Switch Data Control Connections How to Connect the MDLP1Power Control Connections AC Power Cord ConnectionsRemote Control Push-Buttons How to use the Remote Control Front Panel Push-buttons, Indicators and Control Menu Function Setting Default SettingsSource Selection How to Operate the MDLP1Power Image Adjustments and Setting changesKeystone0 Picture Adjust Menu Picture Mode SelectionAspect Ratio Options How to Operate the MDLP1, con’tFine Menu 1 Adjust Fine Menu 2 AdjustInput Signal Resolution Selection RGB/HD Adjust Display Menu AdjustOSD/Blanking Config. Settings Lamp at this time, a Specifications Optical Specifications Electrical SpecificationsGeneral Specifications Packing Instructions McIntosh Laboratory, Inc Chambers Street Binghamton, NY