Picture Mode Selection, Picture Adjust Menu

Wireless ?

Panel. In certain installations it might be desirable to use an external sensor connected to the IR Jack. If an external sensor is used, it is advisable to switch Off the built-in sen- sors to prevent possible interference. To switch Off these sensors perform the following steps:

1.Press the MENU Push-button on either the Projec- tor Control Panel or on the Remote Control. Refer to figures 14 and 15.

2.Using the Navigation ▲UP or ▼DOWN Push-button, select CONFIG. from the Main Menu choices. Refer to figure 21.

Standard 1
Picture Adjust	Auto Power Off		Enable
Fine Menu 1	Trigger 2 Full		On
Fine Menu 2	Trigger 2	Normal	On
Input Signal	Trigger 2	Zoom	On
RGB/HD Adjust	Trigger 2	V-stretch	On
Display	Trigger 2	Through	On
OSD/Blanking	Remote Control
Config.	Reset Lamp Life
	Reset All

Figure 21

3.Using the Navigation ►RIGHT push-button plus the ▲UP or ▼DOWN Push-button, select REMOTE CONTROL from the Config. Menu choices.

4.Press the Navigation ►RIGHT push-button and the On-Screen Display changes to show a window. Refer to figure 22.

5. Press the ◄LEFT or ►RIGHT Navigation

push-button to select	��	��
push-button to select
YES to disable the		Figure 22
enternal sensors or NO
to activate the internal sensors.

6.In order to activate the sensor choice, it is necessary to press the ENTER Push-button on the Control Panel.

Note: The SELECT Push-button on the Remote Control will not activate the choice.

Picture Mode Selection

The MDLP1 has three predefined Picture Modes; Theater, Standard, Dynamic. There are also nine User definable Picture Modes. Refer to figure 23. A Picture Mode is a Memory Location that remembers the current image set- tings which are adjustable for the currently selected input.

There are two ways to select the Picture mode: select- ing a mode from the On-Screen MENU or pressing the Picture Mode push-buttons (THTR, STD, DYN) on the

Standard 1

Picture Adjust	Theater	Default
Fine Menu 1	Standard	1	Default
Fine Menu 2	Dynamic	Default	1
Input Signal	User	1	2
RGB/HD Adjust			3
Display

OSD/Blanking

Config.

Figure 23

Remote Control. To have the MDLP1 memorize the current setting perform the following:

1.Select a memory location (U1 thru U9) and then press the SELECT/ENTER Push-button.

2.Make the changes to the image using the menu sys- tem.

3.Reselect the memory location from step one and then press the SELECT/ENTER Push-button.

Picture Adjust Menu

There are various image adjustments available as follows: Refer to figure 24.

User 1
Picture Adjust	Gamma		A	A
Fine Menu 1	Contrast	0		B
Fine Menu 2	Brightness	0		C
Input Signal	Color	0		D
RGB/HD Adjust	Tint	0		E
Display	Color Temp.		3	Theater
OSD/Blanking	Lamp Mode		Normal	Standard
Config.	Iris		F6.0	Dynamic
	Aspect		Full

Figure 24

Gamma - There are eight different settings changing a narrow range of the gray scale.

Color Temp. - The Color Temperature effects to what de- gree of neutrality the gray scale is.

Setting - Color Temperature (° Kelvin)

15250° K (overall reddish tint)

25800° K (slightly overall reddish tint)

3 6500° K (most neutral, default setting)

4 7500° K (slightly overall bluish tint

5 9300° K (overall bluish tint)

HB	High Bright (Display brightest image)