Keystone0

How to Operate the MDLP1

Display Installation Orientation:

1.Press the MENU Push-button on either the Projec- tor Control Panel or on the Remote Control. Refer to figures 14 and 15.

2.Using the Navigation ▲UP or ▼DOWN Push-button, select DISPLAY from the Main Menu choices. Refer to figure 16.

Standard 1

Fine Menu 1	Keystone	0
Fine Menu 2	Scale	0
Input Signal	Width	0
RGB/HD Adjust	Position H	0
Display	Position V	0
OSD/Blanking	Overscan	Enable	Front
Config.	Installation	Front	Rear

F+Ceiling

R+Ceiling

Figure 16

3.Using the Navigation ►RIGHT push-button plus the ▲UP or ▼DOWN Push-button, select INSTALLA- TION from the Display Menu choices.

4.Press the Navigation ►RIGHT push-button plus the ▲UP or ▼DOWN Push-button select the correct orientation of the projector relative to the screen. Refer to figure 17.

Standard 1
Fine Menu 1	Keystone	0
Fine Menu 2	Scale	0
Input Signal	Width	0
RGB/HD Adjust	Position H	0
Display	Position V	0
OSD/Blanking	Overscan	Enable
Config.	Installation	Front

Figure 17

Vertical Keystone Adjustment:

1.Press the MENU Push-button on either the Projec- tor Control Panel or on the Remote Control. Refer to figures 14 and 15.

2.Using the Navigation ▲UP or ▼DOWN Push-button, select DISPLAY from the Main Menu choices. Refer to figure 17.

3.Using the Navigation ►RIGHT push-button plus the ▲UP or ▼DOWN Push-button, select KEYSTONE from the Display Menu choices.

4.Press the Navigation ►RIGHT push-button and the On-Screen Display changes to show the video image selected plus a horizontal adjustment bar located near the bottom of the screen. Refer to figure 18.

Figure 18

5.Press the ◄LEFT or ►RIGHT Navigation push-button to adjust the image so the left and right vertical sides of the image are parallel to the sides of the screen. Refer to figures 19 and 20.

Note: The ADJUST + and - Push-buttons on the Remote Control may also used.

Figure 19

Figure 20

In order to see the sides of the projected image it might be necessary to temporarily reduce the size of the image by using the Lens Mechanical Size Adjustment, refer to page

14.After the Vertical Keystone correction has been per- formed, the projected image might not fill up the screen. If necessary, use the Lens Mechanical Size Adjustment to correct.

Remote Control Configuration:

The MDLP1 has two built-in sensors, one on the front of the projector and the other sensor located on the Control