Onkyo HT-SR800 instruction manual Listening to the Radio, Listening to AM/FM Stations

HT-SR800_En.book Page 44 Thursday, January 25, 2007 10:28 AM

Listening to the Radio

Listening to AM/FM Stations	Tuning into AM/FM Radio Stations
	■ Auto Tuning Mode
TUNER

TUNING

1 TUNING MODE

Press the [TUNING MODE] button

so that the AUTO indicator

MASTER VOLUME

STANDBY/ON

TUNING PRESET

appears on the display.

STANDBY

MULTI CH

DVD

VCR/DVR CBL/SAT AUX

TAPE TUNER

C D

SETUP ENTER

RETURN

AUX INPUT

2

Press the TUNING Up or Down

PHONES

SETUP MIC

VIDEO

L AUDIO R

A SPEAKERS B

TONE

STEREO LISTENING MODE

DISPLAY DIGITAL INPUT

DIMMER MEMORY TUNING MODE

[

]/[

] button.

TUNING

PRESET

Searching stops when a station is

TUNING MODE

found.

With the built-in tuner, you can enjoy AM and FM radio stations.

1	Use the [TUNER] input selector
	button to select AM or FM.
	In this example, FM has been selected.

TUNER

Band Frequency

(Actual display depends on country.)

■ AM Frequency Step Setup (not North America)

You must specify the AM frequency step used in your area. Note that when this setting is changed, all radio presets are deleted.

1	Press the [SETUP] button, use the Up
	and Down [ ]/[	] buttons to select “0.
	Hardware Setup,” and then press
	[ENTER].
2	Use the Up and Down [ ]/[ ] buttons
	to select “AM Freq,” and then use the
	Left and Right [	]/[ ] buttons to
	select:

10 kHz: Select if 10 kHz steps are used in your area.

9 kHz: Select if 9 kHz steps are used in your area.

3	Press the [SETUP] button.
	Setup closes.

■ Manual Tuning Mode

1		Press the [TUNING MODE] button
	TUNING MODE	so that the AUTO indicator disap-

pears from the display.

2	Press and hold the TUNING Up or
TUNING PRESET	Down [ ]/[ ] button.
	The frequency stops changing when
	you release the button.
	Press the buttons repeatedly to change
	the frequency one step at a time.

The American model changes FM frequency in 0.2 MHz steps, 10 kHz steps for AM. For other models it’s

0.05MHz steps for FM and 9 kHz (or 10 kHz) steps for

AM.

When tuned into a station, the TUNED indicator appears. When tuned into a stereo FM station, the FM STEREO indicator also appears.

FM STEREO

AUTO

TUNED

Tuning into Weak FM Stereo Stations

If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to Manual Tuning mode and listen to the station in mono.

Note:

• You can also use the remote controller’s Up and Down []/[ ] buttons to tune the radio.

44