Onkyo HT-S7300 Audio Adjust, Level Calibration, Equalizer Settings, Multiplex/Mono, Dolby

Level Calibration

This setting is set automatically by Audyssey 2EQ® Room Correction and Speaker Setup function (➔ 28).

Here you can adjust the level of each speaker with the built-in test tone so that the volume of each speaker is the same at the listening position.

■Left, Front High Left, Center*1, Front High Right,

Right, Surr Right, Surr Back Right, Surr Back Left, Surr Left

`–12dBto 0dB to +12dB in 1 dB step.

■Subwoofer*1

`–15dBto 0dB to +12dB in 1 dB step.

Note

•Speakers that you set to “No” or “None” in the

“Speaker Configuration” cannot be selected (➔ 41).

•The speakers cannot be calibrated while the AV receiver is muted.

*1 For the center speaker and subwoofer, the level settings made by using the Audio menu are saved here as the default settings (➔ 26).

Tip

•If you’re using a handheld sound level meter, adjust the level of each speaker so that it reads 75 dB SPL at the listening position, measured with C-weighting and slow reading.

Equalizer Settings

This setting is set automatically by Audyssey 2EQ Room Correction and Speaker Setup function (➔ 28).

■Equalizer

`Audyssey:

This is selected automatically by Audyssey 2EQ Room Correction and Speaker Setup function. The Audyssey indicator will light (➔ 9) and “Dynamic EQ” and “Dynamic Volume” become available (➔ 44).

`Off:

No Audyssey 2EQ equalizing will apply.

Note

•While the Direct listening mode is selected, this setting has no effect.

•Audyssey equalizing does not work for DSD sources.

Audio Adjust

Main menu Audio Adjust

With the Audio Adjust functions and settings, you can adjust the sound and listening modes as you like.

Multiplex/Mono

■Multiplex

This setting determines which channel of a stereo multi- plex source is output. Use it to select audio channels or languages with multiplex sources, multilingual TV broadcasts, and so on.

Input Channel

`Main:

The main channel is output.

`Sub:

The sub channel is output.

`Main/Sub:

Both the main and sub channels are output.

■Mono

This setting specifies the channel to be used for playing any 2-channel digital source such as Dolby Digital, or 2-channel analog/PCM source in the Mono listening mode.

Input Channel

`Left + Right:

Both the left and right channels are output.

`Left:

Only the left channel is output.

`Right:

Only the right channel is output.

Dolby

■PLIIx Music (2ch Input)

These settings apply to only 2-channel stereo sources. If you’re not using any surround back speakers, these settings apply to Dolby Pro Logic II, not Dolby Pro Logic IIx.

Panorama

`On:

Panorama function on.

`Off:

Panorama function off.

With this setting, you can broaden the width of the front stereo image when using the Dolby Pro Logic IIx Music listening mode.

En

42