Sharp XV-Z17000 Computer Image Adjustment SIG-ADJ Menu, 1Adjusting the Computer Image

Computer Image Adjustment (“SIG-ADJ” Menu)

The illustration shown here is for explanation and may be different from the actual on-screen display.

Picture SIG-ADJSCR-ADJ PRJ-ADJ

	Clock				0
	Phase				0
	H-Pos				0
	V-Pos				0
		Reset
	Resolution
*1	Auto Sync					On
	Signal Type					Auto
	Video System					Auto
*2	Video Setup					0 IRE
	Dynamic Range					Auto
			Signal Info : 1080P
		H : XX.X		kHz/			V : XX.X Hz
		SEL./ADJ.					ENTER
		RETURN					END

*1 If the input mode is S-VIDEO or VIDEO input, the display changes to the “Video System” screen.

*2 Displayed when the input mode is HDMI input.

1Adjusting the Computer Image

Use the SIG-ADJ function in case of irregularities such as vertical stripes or flickering in portions of the screen.

Selectable items	Description
Clock	Adjusts vertical noise.
Phase	Adjusts horizontal noise (similar to
	tracking on your VCR).
H-Pos	Centers the on-screen image by
	moving it to the left or right.
V-Pos	Centers the on-screen image by
	moving it up or down.

Note

•You can automatically adjust the computer image by setting “Auto Sync” in the “SIG-ADJ” menu to “On”, or pressing AUTO SYNC on the remote control.

•Depending on the type of input signal, the adjustment range for each setting may vary or the adjustment may not be available at all.

•To reset all adjustment items, select “Reset” and press ENTER.

2Setting the Resolution

Ordinarily, the type of input signal is detected and the correct resolution mode is automatically selected. How- ever, for some signals, the optimal resolution mode in “Resolution” in the “SIG-ADJ” menu may need to be selected to match the computer display mode.

Menu operation ⇒ Page 35

Note

•Avoid displaying computer patterns which repeat every other line (horizontal stripes). (Flickering may occur, making the image hard to see.)

•Information on the currently selected input signal can be confirmed in item 8 on page 42.

3Auto Sync (Auto Sync Adjustment)

Selectable items	Description
On	Auto Sync adjustment will occur when
	the projector is turned on or when
	the input signals are switched, when
	connected to a computer.
Off	Auto Sync adjustment is not
	automatically performed.

Note

•Auto Sync adjustment is also performed by pressing AUTO SYNC on the remote control.

•When setting “Auto Sync” to “Off”, and if AUTO SYNC is pressed, Auto Sync will be ex- ecuted in “On” mode. If the button is pressed again within one minute, Auto Sync will be executed in “On” mode.

•The Auto Sync adjustment may take some time to complete, depending on the image of the computer connected to the projector.

•When the optimum image cannot be achieved with Auto Sync adjustment, use manual adjustments.

4Signal Type Setting

When using an input mode of HDMI1, HDMI2, or COM- PUTER, set the signal type to the corresponding input signal type (RGB or YPbPr).

Selectable items	Description
Auto	Automatically selects the appropriate
	input signal between RGB and YPbPr.
RGB	Set when RGB signals are received.
YPbPr	Set when YPbPr signals are received.

Useful Features

-41