Sharp XG-C60X operation manual Press , , or on the remote control to select the Input mode

3 Press , , or on the remote control to select the INPUT mode.

•After pressing once on the projector, use to select the desired input mode.

Note

•When no signal is received, “NO SIGNAL.” will be displayed. When a signal that the projector is not pre- set to receive is received, “NOT REG.” will be displayed.

•When “Auto Search” is “ON”, the INPUT modes with signals can be selected. (see page 64.)

•The INPUT mode is not displayed when “OSD display” is set to “Level A” or “Level B”. (see page 65.)

About the INPUT modes

INPUT 1	Used for projecting im-
INPUT 2	ages from equipment that
(RGB/	sends RGB signals or
Component)	component signals con-
	nected to the RGB input
	terminal.
INPUT 3	Used for projecting im-
(Video)	ages from equipment
	connected to the VIDEO
	input terminal.
INPUT 4	Used for projecting im-
(S-Video)	ages from equipment
	connected to the S-
	VIDEO input terminal.

4 Press or on the remote control to adjust the volume.

Note

•Pressing will lower the volume.

Pressing will raise the volume.

•On the projector, the volume can be

adjusted by pressing or .

• , on the projector operate

as cursor buttons (\, ) when the menu screen is active.

"On-screen Display (Example)

	➝
INPUT 1 mode
Using RGB

Using
Component
	➝
INPUT 2 mode
Using RGB
Using
Component
INPUT 3 mode	➝
Using Video
INPUT 4 mode	➝	Basic
Using S-Video		Operation

INPUT buttons

VOLUME buttons

-35

XG-C60X_E_PDF_p33_41.p65 35 03.8.28, 2:08 PM