DHD Controller Description, Front Panel | Runco VX-1000d specification

DHD Controller Description

Front Panel

1.RUNCO ICON

When the Red light is displayed the unit is in Standby, when Blue light is displayed the unit is On.

2. POWER BUTTON

Press once to toggle on from Standby mode to On mode, a second time to place into Standby mode. For a discreet on or off command, you can use the direct access buttons on the remote control.

3.IR RECEIVER

Receives the IR commands from the remote.

4.VACUUM FLORESCENT DISPLAY

Reads out all relevant status information of the DHD at all times. Can be used instead of the On Screen Display. Indicates the model number, current source, scan rate (resolution) and aspect ratio.

5.UP BUTTON

Use to direct select aspect ratios or move the menu cursor Up in the On-Screen Display. When no menus are present on-screen, the UP button will toggle you through aspect ratios in the following order:

Anamorphic		Standard (4:3)		Letterbox		VirtualWide

6.LEFT BUTTON

Used to direct select inputs or move the menu cursor Left in the On Screen Display. When no menu is present on-screen,

the LEFT button will toggle you through the different sources, in the order of:

HD Pass Thru 2

HD Pass Thru 1

DVI 2

DVI 1

HD/RGB2

HD/RGB1

Component SD

S-Video 2

S-Video 1

Composite

7.ENTER BUTTON

When an item is highlighted on the On-Screen Display, the ENTER button will select the item.

8.DOWN BUTTON

Use to direct select aspect ratios or move the menu cursor Down in the On-Screen Display. When no menu is present

on-screen, this button will toggle you through the different aspect ratios.

VirtualWide		Letterbox		Standard (4:3)		Anamorphic

9.RIGHT BUTTON

Used to direct select inputs or move the menu cursor Right in the On Screen Display.When no menus are present on- screen, the RIGHT button will toggle you through the different sources, in the order of:

Composite

S-Video 1

S-Video 2

Component SD

HD/RGB 1

HD/RGB 2

DVI 1

DVI 2

HD Pass Thru 1

HD Pass Thru 2

10.MENU BUTTON

Pressing the MENU button will bring up the main menu. Also, if you are in an adjustment mode or function, pressing MENU will bring the menu back one level.