Runco VX-1000d manual Menu Description and Navigation, Main Menu

Menu Description and Navigation

Main Menu

When the MENU button is pressed on either the remote control or the front panel, the main menu will appear on-screen. An example of the main menu is shown above.

Opening Screen

•Press ENTER to access the Input Source selection menu

•Press ENTER to access the Aspect Ratio selection menu

•Press ENTER to access the Picture setting menu

•Press ENTER to access the Input Position setting menu

•Press ENTER to access the ISF and Custom Presets menu

•Press ENTER to receive information about the controller

Runco Video

Input Source

Aspect Ratio

Picture

Input Position

ISF Presets

Information

The active source is indicated by an arrow to the left of the source; note that in the example to the right, Composite is the current source.

	Input Source
Input Source
	Composite
Indicates selection has been made for the Input Source selection menu
• Press ENTER to select the Composite input	S Video 1
• Press ENTER to select the S-Video input
	S Video 2
• Press ENTER to select the Picture setting menu
	Component SD
• Press ENTER to select the Input Position setting menu
• Press ENTER to select the ISF and Custom Presets menu	HD/RGB 1
• Press ENTER to receive information about the controller	HD/RGB 2
To select a source via the main menu, press either the up or down buttons	DVI 1
on the remote or front panel and highlight the desired source, and press	DVI 2
ENTER. Otherwise, you may select a source by pressing either the left or	HD Pass Thru 1
right arrow buttons (on the remote or front panel) when no menus are
on-screen, or by pressing one of the direct access buttons on the remote	HD Pass Thru 2
control (recommended).

NOTE: If DVI input is used with HDCP content, RGBHV output is automatically disabled. This is in compliance with HDCP regulations.

If pass-through is selected, note that no on-screen menus will be displayed since the signal is simply being 'looped' directly to the output. When pass-through is the selected source, pressing MENU will not automatically select the last selected input before Pass-through was selected. If you wish to choose another source, Runco recommends using the direct access buttons to select the desired source as opposed to pressing MENU.

17