Runco VX-1000d manual Projector Placement and Offset Information, Ceiling Mount Configuration

Page 11

Projector Placement and Offset Information

Ceiling Mount Configuration

	10.250
	6.546
1.645	3.500
1.645	Projector Base B
	3.500
8.830	Base plate to center of lens
		angle
		Screen Top	Half Screen
			Half Screen
	A		Length

Screen Center

Full Screen Length

SCREEN (H) x (W)

B) THROW DISTANCE FOR 16 x 9 SCREENS:

Minimum: = (screen width x 1.85) = __________ inches

Maximum: = (screen width x 2.4) = __________ inches

C) VERTICAL OFFSET:

Distance between lens center and top edge of viewing area (bottom edge for floor mount): Between 0 and (0 - screen height)

Floor Mount Configuration

A

angle

8.200	3.500
	Base plate to center of lens

Projector Base

B 1.015

NOTE: These figures are the same for both ceiling and floor configurations.

Screen Top		Full Screen Length

Screen Center

Half Screen

Length

10

Image 11

Contents VX-1000d Projector Table of Contents Page Introduction FeaturesProduct Disposal Information Declaration of Conformity Intellectual Property Rights Read Before Using the ProductLimited Warranty Limited WarrantyEffective Warranty Date Features and Benefits Input Panel Projector DescriptionTop View Vertical Offset Projector Placement and Offset InformationCeiling Mount Configuration Floor Mount ConfigurationFront Panel DHD Controller DescriptionRear Panel Remote Control Description Analog Inputs Quick Set-up GuideConnection Examples Digital Inputs Projector ConfigurationOverall Functional Description Main Menu Menu Description and NavigationAspect Ratio White Yellow Cyan Green Magenta Red Blue Input Position Problem Possible Cause Solution Basic Troubleshooting TipsImage appears too General Information RS-232 CommunicationsDescription RS-232 CommandsBrightness VX-1000d Projector SpecificationsDHD Controller Supplied AccessoriesRUMA-010825 Rev 9-20-04 ver