Runco VX-22D Turning on the Power, Adjusting the Picture Orientation, Connecting to AC Power

Installation

Projector/DHD Controller: Plug the female end of one power cord into the AC		Connecting to AC Power
receptacle on the rear of the VX-22d (AC 100V ~ 240V). Then, connect the other end to
your AC power source.
Similarly connect the DHD Controller to a nearby AC outlet.
AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC
input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power
source.
Caution	The input voltage to the AutoScope lens motor must be between
	100 and 120 VAC. Do not connect the AutoScope lens motor

to a 200-240 VAC power source!

1.Turn on your source components.

2.Turn on the main power switch at the rear of the projector.

3.Turn on the main power switch at the rear of the DHD Controller.

4.Press the ON button on the remote control – or the SOFT PWR button on the DHD Controller front panel – to turn on the system. The vacuum fluorescent display on the DHD Controller front panel briefly displays “Starting Display.”

5.When the projector is ready for use (after about 20 seconds), the RUN LED on the DHD Controller front panel lights solid blue. The fluorescent display indicates the current input source, aspect ratio and input resolution; for example:

Current Input Source

3.8

Turning on the Power

VX-22d Component RCA

16:9480I

Aspect Ratio Input Resolution

By default, the VX-22d is configured for a “floor/front” installation, in which the projector is installed upright and in front of the screen. If it is installed behind the screen and/or inverted, you must change the picture orientation. To do this:

1.Press MENU.

2.Select Service from the Main Menu and enter the Service Menu passcode.

3.Select Display Device from the Service Menu.

4.Select Installation from the Display Device menu.

5.Choose Floor Rear, Ceiling Front or Ceiling Rear, to match the installation method.

You must enter a passcode to access the Service menu.

Note

3.9

Adjusting the Picture Orientation

Runco VX-22d Owner’s Operating Manual 37