Sharp PG-D2710X appendix Inserting the Batteries, Usable Range, Remote control signal transmitters

Inserting the Batteries

1 Pull down the tab on the cover and remove the cover towards the direction of the arrow.

2 Insert the batteries.

• Insert the batteries making sure the polarities correctly match the m and n marks inside the battery compartment.

3 Insert the lower tab of the cover into the opening, and lower the cover until it clicks in place.

Incorrect use of the batteries may cause them to leak or explode. Please follow the precautions below

Caution

•Danger of explosion if battery is incorrectly replaced. Replace only with alkaline or manganese batteries.

•Insert the batteries making sure the polarities correctly match the m and n marks inside the battery compartment.

•Batteries of different types have different properties, therefore do not mix batteries of different types.

•Do not mix new and old batteries.

This may shorten the life of new batteries or may cause old batteries to leak.

•Remove the batteries from the remote control once they have run out, as leaving them in can cause them to leak. Battery fl uid from leaked batteries is harmful to skin, therefore ensure you wipe them fi rst and then remove them using a cloth.

•The batteries included with this projector may run down in a short period, depending on how they are kept. Be sure to replace them as soon as possible with new batteries.

•Remove the batteries from the remote control if you will not be using the remote control for a long time.

•Comply with the rules (ordinance) of each local government when disposing of worn-out batteries.

Usable Range	Remote control sensor
The remote control can be used to control the
projector within the ranges shown in the
illustration.
Note
• The signal from the remote control can be	30°
refl ected off a screen for easy operation.
However, the effective distance of the signal
may differ depending on the screen material.

Introduction

When using the remote control

•Ensure that you do not drop it or expose it to moisture or high temperature.

•The remote control may malfunction under a fl uorescent lamp. In this case, move the projector away from the fl uorescent lamp.

30° 33 n (10 m)

Remote control signal transmitters

Remote control

15