Sharp PG-D3510X, PG-D2710X, PG-D3010X specifications Connecting the Projector to a Computer

Page 12

Setting up the Projector Network Environment

1.Connecting the Projector to a Computer

Establishing a one-to-one connection from the projector to a computer. Using a commercially available LAN cable (UTP cable, Category 5, cross-over type) you can configure the projector via the computer.

1 Disconnect the computer's LAN cable from the existing network.

A LAN cable being

connected to the network

2 Connect a commercially available LAN cable (UTP cable, Category 5, cross-over type) to the projector's LAN terminal and connect the other end of the cable to the computer's LAN terminal.

LAN cable

(cross-over type, commercially available)

3

4

Plug the power cord into the AC socket of the projector.

Turn on the computer.

ON

Info

Confi rm that the LINK LED on the rear of the projector illuminates. If the LINK LED does not illuminate, check the following:

The LAN cable is properly connected.

The power switches of both the projector and the computer are on.

This completes the connection. Now proceed to “2. Setting an IP Address for the Computer”.

-12

Image 12
Contents Setup Manual Connecting Pin Assignments Sub 15 pin female connectorConnecting Pin Assignments RS-232C Specifications and Commands Computer control Communication conditionsBasic format Commands W RDNR Video Input Picture Mode Standard OK or ERR PAL Control Contents Command Operating the Projector Using the PJLinkTM Protocol SharpSetting up the Projector Network Environment Network settings on the computerConnecting the Projector to a Computer Setting an IP Address for the Computer Set temporarily as follows Setting up a Network Con- nection for the Projector DNS Controlling the Projector Using Internet Explorer Controlling the Projector via LANConfirming the Projector Controlling the ProjectorSetting and Adjusting Setting the SecurityMaking General Settings for Setting for Sending E-mail when an Error OccursMail Recipient Settings Resetting the Lamp Timer of the Projector via LAN Resetting the Lamp Timer of the Projector via LAN Troubleshooting Communication cannot be established with the projectorTroubleshooting \ After the initialization, carry out setting again
Related manuals
Manual 75 pages 61.94 Kb