Sharp PG-D3510X, PG-D2710X, PG-D3010X specifications Connecting Pin Assignments

Page 3

Connecting Pin Assignments

RS-232C Cable recommended connection: D-sub 9 pin female connector

5	1	Pin No.	Signal	Pin No.	Signal
		1.	CD	1.	CD
		2.	RD	2.	RD
		3.	SD	3.	SD
		4.	ER	4.	ER
		5.	SG	5.	SG
		6.	DR	6.	DR
9	6	7.	RS	7.	RS
9	6	8.	CS	8.	CS
		9.	CI	9.	CI

Note

•Depending on the controlling device used, it may be necessary to connect Pin 4 and Pin 6 on the controlling device (e.g. computer).

Projector	Computer
Pin No.	Pin No.

4

5

6

4

5

6

USB Terminal: Type B USB connector

LAN Terminal: LAN (RJ-45)

	4 3					Pin No.	Signal	Name
						1.	VCC	USB power
						2.	USB–	USB data–
						3.	USB+	USB data+
						3.	USB+	USB data+
						4.	SG	Signal Ground


	1 2

Pin No.	Signal	Pin No.	Signal
1.	TX+	5.
2.	TX–	6.	RX–
3.	RX+	7.

4.8.

8 ... 1

-3

Image 3

Contents Setup Manual Sub 15 pin female connector Connecting Pin AssignmentsConnecting Pin Assignments RS-232C Speciﬁcations and Commands Computer control Communication conditionsBasic format W R CommandsDNR Video Input Picture Mode Standard OK or ERR PAL Control Contents Command Sharp Operating the Projector Using the PJLinkTM ProtocolNetwork settings on the computer Setting up the Projector Network EnvironmentConnecting the Projector to a Computer Setting an IP Address for the Computer Set temporarily as follows Setting up a Network Con- nection for the Projector DNS Controlling the Projector via LAN Controlling the Projector Using Internet ExplorerControlling the Projector Conﬁrming the ProjectorSetting the Security Setting and AdjustingSetting for Sending E-mail when an Error Occurs Making General Settings forMail Recipient Settings Resetting the Lamp Timer of the Projector via LAN Resetting the Lamp Timer of the Projector via LAN Communication cannot be established with the projector TroubleshootingTroubleshooting \ After the initialization, carry out setting again

Related manuals

Manual 75 pages 61.94 Kb