Controlling the Projector via LAN
Confirming the Projector
Status (Status)
Controlling the Projector
(Control)
2 30
1
On this screen, you can confirm the projector status. You can confirm the following items:
•MAC Address
•Power
•Condition
•Lamp Timer
•Lamp Life
•Input
•Signal Info
•Serial Number
Note
•If you click the “Refresh” button before the screen is displayed completely, an error message (“Server Busy Error”) will be displayed. Wait for a moment and then operate again.
•For details about each item, refer to the projector's operation manual.
On this screen, you can perform projector control. You can control the following items:
•Power
•Input Select
•Audio Input
•Volume
•AV Mute
Note
•If you click the “Refresh” button before the screen is displayed completely, an error message (“Server Busy Error”) will be displayed. Wait for a moment and then operate again.
•You cannot operate this page while the projector is warming up.
•While the projector is in standby mode, you can only control “Power ON”.
•For details about each item, refer to the projector's operation manual.
-18