Sharp PG-D3010X, PG-D3510X, PG-D2710X specifications Controlling the Projector via LAN

Page 17

Controlling the Projector via LAN

After connecting the projector to your network, enter the projector IP address in “Address” on Internet Explorer (version 6.0 or later) using a computer on the network to start a setup screen that will enable control of the projector via the network.

Controlling the Projector

Using Internet Explorer

Complete connections to external equipment before starting the operation. (See pages 21-25 of the projector's operation manual.)

Complete the AC cord connection. (See page 25 of the projector's operation manual.)

Note

•When connecting the projector to the LAN, use a commercially available LAN cable (UTP cable, Category 5, cross-over type). When connecting the projector to a hub, use a straight-through cable.

1

2

Start Internet Explorer on the computer.

Enter “http://” followed by the projector IP address set by the procedure on page 16 followed by “/” in “Address”, and then press the “Enter” key.

•When “DHCP Client” is set to “OFF” on the projector, IP address is 192.168.150.2. If you did not change the IP address in “3. Setting up a Network Connection for the Projector” (pages 15-16), enter “http://192.168.150.2/”.

3 A screen for controlling the projector appears, ready for performing various status conditions, control, and settings.

-17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Setup Manual Sub 15 pin female connector Connecting Pin AssignmentsConnecting Pin Assignments Basic format RS-232C Specifications and CommandsComputer control Communication conditions W R CommandsDNR Video Input Picture Mode Standard OK or ERR PAL Control Contents Command Sharp Operating the Projector Using the PJLinkTM ProtocolNetwork settings on the computer Setting up the Projector Network EnvironmentConnecting the Projector to a Computer Setting an IP Address for the Computer Set temporarily as follows Setting up a Network Con- nection for the Projector DNS Controlling the Projector via LAN Controlling the Projector Using Internet ExplorerControlling the Projector Confirming the ProjectorSetting the Security Setting and AdjustingSetting for Sending E-mail when an Error Occurs Making General Settings forMail Recipient Settings Resetting the Lamp Timer of the Projector via LAN Resetting the Lamp Timer of the Projector via LAN Communication cannot be established with the projector TroubleshootingTroubleshooting \ After the initialization, carry out setting again
Related manuals
Manual 75 pages 61.94 Kb
Top Page Image Contents