Sharp PG-D3010X, PG-D3510X, PG-D2710X After the initialization, carry out setting again

Page 26

Troubleshooting

\Check if the “TCP/IP” protocol is operating correctly using the “PING” command. Also, check if an IP address is set.

1.Open a command prompt.

In the case of Windows® 2000: click “start” “Programs” “Accessories” “Command Prompt” in order.

In the case of Windows® XP, Windows Vista®: click “start” “All Programs” “Accessories” “Command Prompt” in order.

2.After launching the command prompt enter a command “PING”. Entry example C:\>ping XXX.XXX.XXX.XXX

“XXX.XXX.XXX.XXX” should be entered with an IP address to be connected to, such as the projector.

3.When connecting normally, the display will be as follows.

(The screen may be slightly different depending on the OS type.) <Example> when the IP address connected to is “192.168.150.1”

4.When a command cannot be sent, “Request time out” will be displayed. Check the network setting again.

If communication can still not be established properly, contact your network administrator.

5.To return to the Windows® screen, enter “exit” and then press the “Enter” key.

\When the projector cannot be connected, even though the “PING” command is checked:

1.When “Accept IP Address” is set on the projector, set the IP address of the PC to be connected.

2.When a security software is installed on the PC, or when a fi re wall has been set up for the network system, connection may not be possible. Consult the system administrator when, for example, you want to change the settings to enable use of the TCP port set as the data port.

3.When neither of the above two items applies, change the settings for the data port.

A connection cannot be made because you have forgotten your user name or your password.

\Initialize the settings. (See page 55 of the projector's operation manual.)

\After the initialization, carry out setting again.

-26

Image 26
Contents Setup Manual Connecting Pin Assignments Sub 15 pin female connectorConnecting Pin Assignments Basic format RS-232C Specifications and CommandsComputer control Communication conditions Commands W RDNR Video Input Picture Mode Standard OK or ERR PAL Control Contents Command Operating the Projector Using the PJLinkTM Protocol SharpSetting up the Projector Network Environment Network settings on the computerConnecting the Projector to a Computer Setting an IP Address for the Computer Set temporarily as follows Setting up a Network Con- nection for the Projector DNS Controlling the Projector Using Internet Explorer Controlling the Projector via LANConfirming the Projector Controlling the ProjectorSetting and Adjusting Setting the SecurityMaking General Settings for Setting for Sending E-mail when an Error OccursMail Recipient Settings Resetting the Lamp Timer of the Projector via LAN Resetting the Lamp Timer of the Projector via LAN Troubleshooting Communication cannot be established with the projectorTroubleshooting \ After the initialization, carry out setting again
Related manuals
Manual 75 pages 61.94 Kb