Dns

Setting up the Projector Network Environment

4 The TCP/IP setting screen appears, ready for network settings for the projector.

Items	Setting example / Remarks
New	You can set the password to protect
Password	the TCP/IP setting.
DHCP	Select “ON” or “OFF” to determine
Client	whether to use DHCP Client.
IP	You can set this item when “DHCP
Address	Client” is set to “OFF”.
	Factory default setting: 192.168.150.2
	Enter an IP address appropriate for
	the network.
Subnet	You can set this item when “DHCP
Mask	Client” is set to “OFF”.
	Factory default setting:
	255.255.255.0
	Set the subnet mask to the same as
	that of the computer and equipment
	on the network.
Default	You can set this item when “DHCP
Gateway	Client” is set to “OFF”.
	Factory default setting: 0.0.0.0
	* When not in use, set to “0.0.0.0”.
DNS	Factory default setting: 0.0.0.0
Server	* When not in use, set to “0.0.0.0”.

Note

•Conﬁ rm the existing network's segment (IP address group) to avoid setting an IP address that duplicates the IP addresses of other network equipment or computers. If “192.168.150.2” is not used in the network

having an IP address of “192.168.150.XXX”, you don't have to change the projector IP address.

• For details about each setting, consult your network administrator.

Click the “Apply” button.

The set values appear. Conﬁrm that the values are set properly, and then click the “Conﬁrm” button.

•Close the browser.

•This completes the network settings.

•After setting items, wait for about 15 seconds and then re-access.

•Change the IP address of the setting computer back to its original address, which you have noted down in Step 6-1 on page 14, and then connect the computer and the projector to the network.

-16

DHCP