Vidikron Vision 110 Connecting an External IR, Receiver to the Vision, Rear Panel, Power source

Installation

Connecting an External IR ➤	If infrared signals from the remote control cannot reach the projector due to excessive
Receiver to the Vision 110	distance or obstructions such as walls or cabinet doors, you can connect an external IR
	receiver to the WIRED REMOTE input on the Vision 110 to extend the range of the remote
	control. See Figure 3-17.
	IR Receiver
	Remote
	Control

SOU RCE

R ENTE

	Y
	TIO
PICTURE	RA
	ASPECT

	6	0
2	5	9

14

8

3 7

Ring = +5V

Tip = IR Input

Sleeve = Ground

Rear Panel

WIRED REMOTE

REMOTE WIRED

(3.5-mm mini phono plug)

Service port. Not for user access

Figure 3-17. External IR Receiver Connection

When an external IR receiver is connected to the wired IR input, the

Note built-in IR sensor on the Vision 110 is disabled.

Connecting to AC Power ➤ Projector: Plug the female end of one power cord into the AC receptacle on the rear of the Vision 110 (AC 100V ~ 240V). Then, connect the other end to your AC power source.

AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power cord is provided for the lens motor. Plug the female end of the AC power cord into the AC input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power source.

Caution	The input voltage to the AutoScope lens motor must be between 100 and
	120 VAC. Do not connect the AutoScope lens motor to a 200-240 VAC
	power source!

36 Vidikron Vision Model 110 Installation/Operation Manual