Univex 700 manual Using the Direct Power On Function, Choose Direct Power On and press Enter

The projector beeps once and the P power light flashes green as the projector warms up, then an image begins to appear. When the P power light stops flashing and remains green, the projector is ready for use.

4. If you are prompted to enter a password, see page 65.

Using the Direct Power On Function

The Direct Power On function enables faster setup. The projector starts up automatically when you plug it in or turn it on with a wall switch. You don’t have to press the P power button.

Follow these steps to enable Direct Power On:

1.Press the Menu button on the remote control or projector, then select the Extended menu and press Enter.

2.Choose Operation and press Enter.

3.Choose Direct Power On and press Enter.

warning

Never look into the lens when the lamp is on. This can damage your eyes, and is especially dangerous for children.

4.Highlight On and press Enter.

5.Press Menu to exit. The setting will take effect the next time you plug in the projector.

note

If a power outage occurs when Direct Power On is enabled and the projector is plugged in, the projector will restart when the power is restored.

Setting Up the Projector

37