Mounting the Switch | OmniSwitch 6600 Series Chassis and Hardware Components |
|
|
|
|
7Once the screws at the bottom of each flange are secure, install the remaining two rack mount screws. Be sure that all screws are securely tightened.
Note. If you are installing multiple switches in a rack to form a stacked configuration, refer to the “Rack Mounting Stacked Configurations” section below.
Rack Mounting Stacked Configurations
If you are rack mounting multiple switches in a stacked configuration, be sure to place all switches in
1Install the rack mount flanges for all switches that are to be included in the stacked configuration, as described on page
2Place the next switch in the stack directly on top of the previously installed switch.
3Align the holes in the flanges with the holes in the rack’s vertical posts.
4Once the holes are aligned, insert a rack mount screw through the bottom hole of each flange. Tighten both screws until they are secure.
5Repeat steps 1 through 4 above for all remaining switches.
page | OmniSwitch 6600 Series Hardware Users Guide April 2004 |