OmniSwitch 6600 Series Chassis and Hardware Components | Removing Uplink and Stacking Modules |
|
|
|
|
Removing Uplink and Stacking Modules
To remove an uplink or stacking module from the chassis, follow the steps below:
1Loosen the two captive screws, located at the left and right sides of the module’s front panel. If neces- sary, use a Phillips screwdriver to loosen the screws.
Note. Be sure that both captive screws are completely disengaged from the threaded holes in the chassis before continuing.
1
2 LINK/ACT LINK/ACT
Loosening the Captive Screws
OmniSwitch 6600 Series Hardware Users Guide April 2004 | page |