AMX AXB-IRS4 RS-232 Protocol Commands Channel Pulse Time, RS-232 Protocol Commands Carrier

Programming

RS-232 Protocol Commands (IR Output - Cont.)
Command	Description
ON[Dev,Chan]	Start IR output on the designated device and channel.
	Variable:
	Dev = 1-4, Chan = 1-252
	Example:
	ON[1,11]
	Starts device 1 and transmits command number 11.
SP[Dev,Chan]	Transmit single IR code pulse. This command will pulse the actual IR code.
	Pulse time is set by the CTON and CTOF commands.
	Variable:
	Dev = 1-4, Chan = 1-252
	Example:
	SP[1,2]
	Transmits command number 2 pulses to device 1.
RS-232 Protocol Commands (Channel Pulse Time)
RS-232 Protocol Commands (Channel Pulse Time)
Command	Description
CTOF(Dev,Time)	Set the channel's off-time pulse in tenths of a second. Default time is 5 (0.5
	second). Time is stored in non-volatile RAM.
	Variable:
	Dev = 1-4, Time = 1-255
	Example:
	CTOF(1,10)
	Sets channel off-time pulse to one second on device 1.
CTON(Dev,Time)	Set the channel's on-time pulse in tenths of a second. Default time is 5 (0.5
	second). Time is stored in non-volatile RAM.
	Variable:
	Dev = 1-4, Time = 1-255
	Example:
	CTON(1,10)
	Sets on-time pulse to 1 second on device 1.

RS-232 Protocol Commands (Carrier)

RS-232 Protocol Commands (Carrier)

Command	Description
CAROFF(Dev)	Disable carrier from responding until a CARON command is received. This command
	overrides the DIP switch setting on the front panel.
	Variable:
	Dev = 1-4
CARON(Dev)	Enable the carrier to respond according to DIP switch settings on the front panel.
	Variable:
	Dev = 1-4

AXB-IRS4 IR/Serial Interface (4 Ports) 15