AMX NXI manual ESC Pass Codes, Escape Pass Codes

Programming

Program Port Commands (Cont.)

SHOW NOTIFY	Displays a list of devices that other systems have requested input from
	and the types of information needed. Note that the local system number is
	1061.
SHOW REMOTE	Displays a list of the devices this system requires input from and the types
	of information needed. When a NetLinx master connects to another
	NetLinx master, the newly connecting system has a device that the local
	system desires input from; the new system is told what information is
	desired from what device. Note the local system number is 1062.
SHOW ROUTE	Displays information about how this NetLinx master is connected to other
	NetLinx masters.
SHOW SYSTEM	Provides a list of all devices in all systems currently on-line. The system’s
	lists are either directly connected to this master (i.e. 1 hop away), or are
	referenced in the DEFINE_DEVICE section of the NetLinx program. You
	may provide the desired system number as a parameter to display only
	that system's information (e.g. SHOW SYSTEM 2001). The systems listed
	are shown in numerical order.
TCP LIST	Lists all active TCP/IP connections.
TIME	Displays the current time on the Master Card.
URL LIST <D:P:S>	Displays the list of URL addresses programmed in the Master Card.

ESC Pass Codes

There are 'escape' codes in the pass mode. These codes can switch the display mode or exit pass mode. The following 'escape' codes are defined.

Escape Pass Codes

Command	Description
+ + ESC ESC	Exit Pass Mode:
	Typing a plus (shift =) followed by another plus followed by an ESC (the escape
	key) followed by another escape exits the pass mode. The Telnet session
	returns to "normal".
+ + ESC A	ASCII Display Mode:
	Typing a plus (shift =) followed by another plus followed by an ESC (the escape
	key) followed by an 'A' sets the display to ASCII mode. Any ASCII characters
	received by the device will be displayed by their ASCII symbol. Any non-ASCII
	characters will be displayed with a \ followed by two hex characters to indicate
	the characters hex value.
+ + ESC D	Decimal Display Mode:
	Typing a plus (shift =) followed by another plus followed by an ESC (the escape
	key) followed by a 'D' sets the display to decimal mode. Any characters
	received by the device will be displayed with a \ followed by numeric characters
	to indicate the characters decimal value.
+ + ESC H	Hex Display Mode:
	Typing a plus (shift =) followed by another plus followed by an ESC (the escape
	key) followed by an 'H' sets the display to hexadecimal mode. Any characters
	received by the device will be displayed with a \ followed by two hex characters
	to indicate the characters hex value.

10 NXI NetLinx Integrated Controller