AMX NXI manual Pon, Ptof, Pton, SET IO Link, SET Mode

Programming

IR/Serial Send_Commands (Cont.)

PON	If at any time the IR sensor reads that the device is off (such as if one turned it
Turns on a device, based on	off manually at the front panel), the card automatically attempts to turn the
	device back on. If three attempts fail, card will continue executing commands in
input Link.
	the buffer. If there are no commands in the buffer, the card will continue to try
	until a 'POF' or 'POD' command is received. If it fails to turn the device on, a
	PUSH and RELEASE is made on channel 254 to indicate a power failure error.
	Channel 255 changes are disabled after receipt of this command.
	You can only use the PON and POF commands when an IR device has a
	linked I/O channel.
	Syntax:
	SEND_COMMAND <DEV>,'PON'
	Example:
	SEND_COMMAND IR_1,'PON'
	Sends power up IR commands 27 or 9 to the IR_1 port.
PTOF	Syntax:
Sets the time between power	SEND_COMMAND <DEV>," 'PTOF',<Time>"
pulses in .10-second incre-	Variable:
ments, and is stored in per-
	Time = 0-255 in tenths of a second increments; default = 15 (1.5 seconds).
manent memory.
	Example:
	SEND_COMMAND IR_1," 'PTOF',15"
	Sets the time between power pulses to 1.5 seconds for the IR_1 device.
PTON	Syntax:
Sets the duration of power	SEND_COMMAND <DEV>," 'PTON',<Time>"
pulses in .10-second incre-	Variable:
ments. Time is stored in per-
	Time = 0-255 in tenths of a second increments; default = 5 (.5 seconds).
manent memory.
	Example:
	SEND_COMMAND IR_1," 'PTON',15"
	Sets the duration of the power pulse to 1.5 seconds for the IR_1 device.
SET IO LINK	The I/O status is automatically reported on channel 255 on the IR port.
Links an IR or Serial port to	Syntax:
an I/O channel for use with	SEND_COMMAND <DEV>,"'SET IO LINK <Number>'
DE, POD, PON and POF
	Variable:
commands.
	Number = 1-8; set the I/O channel to 0 to disable I/O link settings.
	Example:
	SEND_COMMAND IR_1," 'SET IO LINK 1'"
	Sets the IR_1 port link to I/O channel 1. The IR port uses the specified I/O input
	as power status for processing PON and POF commands.
SET MODE	Syntax:
Sets the IR/Serial ports for IR	SEND_COMMAND <DEV>, 'SET MODE <Mode>'
or Serial-controlled devices	Variable:
connected to a CardFrame or
NetModule.	Mode = IR or Serial
	Example:
	SEND_COMMAND IR_1, 'SET MODE IR'
	Sets the IR_1 port to IR mode for IR control.

18 NXI NetLinx Integrated Controller