AMX NXI manual Ctof, Cton, GET Mode, Iroff, Pod, Pof

	Programming
IR/Serial Send_Commands (Cont.)
CTOF	This command is associated with the SP (single pulse) and CP (clear pulse)
Sets the duration of off time	commands.
	Syntax:
(no signal) between IR pulses
for channel and IR function	SEND_COMMAND <DEV>,"'CTOF',<Time>"
transmissions. Off time set-
	Variable:
tings are stored in non-vola-
tile memory. The factory	Time = 0-255 in tenths of a second increments
default for channel off time is	Example:
5 (.5 second).
	SEND_COMMAND IR_1,"'CTOF',10"
	Sets the off time between each IR pulse to 1 second.
CTON	Syntax:
Sets the total time of IR	SEND_COMMAND <DEV>," 'CTON',<Time>"
pulses transmitted, and is	Variable:
stored in non-volatile mem-
	Time = 0-255 in tenths of a second increments; default = 5 (.5 second).
ory.
	Example:
	SEND_COMMAND IR_1,"'CTON',20"
	Sets the IR pulse duration to 2 seconds.
GET MODE	Syntax:
Polls the IR/Serial ports and	SEND_COMMAND <DEV>, 'GET MODE'
reports the active mode set-	Example:
tings to the device request-
	SEND_COMMAND IR_1,'GET MODE'
ing the information.
	System response example:
	PORT 4 IR,CARRIER,IO LINK 0
IROFF	Syntax:
Halts and clears all IR output	SEND_COMMAND <DEV>,'IROFF'
on the designated port.	Example:
	SEND_COMMAND IR_1,'IROFF'
	Immediately halts and clears all IR output signals on the IR_1 port.
POD	Channel 255 changes are enabled. This command is used in conjunction with
Disables active PON (power	the I/O Link command.
on) or POF (power off) com-	Syntax:
mand settings.	SEND_COMMAND <DEV>,'POD'
	Example:
	SEND_COMMAND IR_1,'POD'
	Disables PON and POF command settings on the IR_1 device.
POF	If at any time the IR sensor reads that the device is on (such as if one turned it
Turns off a device, based on	on manually at the front panel), the card automatically attempts to turn the
	device back off. If three attempts fail, the card will continue executing com-
input Link.
	mands in the buffer. If there are no commands in the buffer, the card will con-
	tinue to try until a 'PON' or 'POD' command is received. If it fails to turn the
	device off, a PUSH and RELEASE is made on channel 254 to indicate a power
	failure error.
	Channel 255 changes are disabled after receipt of this command.
	You can only use the PON and POF commands when an IR device has a
	linked I/O channel.
	Syntax:
	SEND_COMMAND <DEV>,'POF'
	Example:
	SEND_COMMAND IR_1,'POF'
	Sends power down IR commands 28 (if present) or 9 to the IR_1 device.

NXI NetLinx Integrated Controller 17