Agilent Technologies E2050-90003 manual Installing the Hardware, Record LAN Hardware Address

Installation

Installing the Hardware

Installing the Hardware

This section shows how to install the LAN/GPIB Gateway hardware by connecting it to the LAN, GPIB bus, and power module.

Step 1: Record LAN Hardware Address

First, find the hardware address of the LAN interface in the E2050 LAN/GPIB Gateway. Turn the Gateway over and look for the label on the underside of the Gateway. The hardware address on the label will be similar to 0800XXXXXX. Write down this address, as you may need it later to configure the Gateway on the network.

CAUTION: Use only Agilent Technologies specified AC - DC adaptor.

CAUTION: No operator serviceable parts inside.

Refer servicing to qualified personnel.

POWER: Input: 5V DC, 6 watts

N279

ISM 1-A

Made in U.S.A. of domestic and foreign components

LAN HARDWARE ADDRESS 0800fffffef6

Finding the LAN Hardware Address (MAC) Step 2: Configure the Network

nIf you purchased the optional rack mount kit, follow that kit’s documentation to assemble the rack and to install the Gateway in the rack’s frame.

nMake sure the GPIB instrumentation you will connect to the Gateway is working properly and is connected to the GPIB bus.

Chapter 2 27