MULTITASKER™
7.4.4 MT109-100 MENUS
Following are the menus available to the
The expanded menu contains values in parentheses that indicate the current setting or value of that parameter. In some areas, additional comments are provided for clarification.
System prompts requiring specific values for volume, card number etc. are not shown. See the examples following the menus for details.
CAUTION: Pay special attention to the top of the CONTROL menu. After selecting the CONTROL menu, THIS CARD or a group will be identified at the top of the
1: CONTROL
SELECT CARD/GROUP
SAVE
CLEAR
SWITCH
VOLUME
MUTE
2: SETUP
SET GROUP
SET INPUT VOLUME
SET RAMP TIME
3:STATUS
4:HELP
21 |
7.4.5 MENU MODE EXAMPLES
All Menu Mode examples assume an
1. Select An Input
Follow the keystrokes below to select Input 3 as the source input.
Enter | List available cards |
01Select
1Select CONTROL Menu
1 | Select Card/Group Select |
0Select This Card (card #1) The CONTROL menu will read THIS CARD at the top.
ESC | Accept this selection |
4 | Select SWITCH |
3 | Select Input 3 |
ESC | Return to CONTROL Menu |
ESC | Return to the Main Menu |
2.Set Input 3 Input Volume
Starting from the main menu, set Input 3 volume level to 16. Follow the keystrokes below.
2 Select SETUP Menu
2Select Set Input Volume
3Select Input 3 Volume
16Enter 16
NOTE The system may echo the 1 and the 6 entries depending on the software settings.
ESC | Return to SETUP |
ESC | Return to the Main Menu |
3.Set Output Volume
Starting from the Main Menu set the output volume level to 16 using the keystrokes below.
1Select CONTROL Menu
5Select VOLUME
1or 2 Use “1” to increase and “2” to decrease until the desired level is obtained.
ESC | Return to CONTROL menu |
ESC | Return to the Main Menu |
21