MULTITASKER™
Example:
Group 5 consists of cards 2, 4 and 6. Group 2 consists of cards 1, 2, 3, 4 and 5. Delete all the groups by sending the command [RMG*]. The system will return the following feedback:
45.[RD]
This command reads and then displays the members in each group.
Command Format: [RDGkUi]
Gk = Group ID (k = # from
Ui = Unit ID (i = # from
Example:
The cards in slots 2, 4 and 6 are part of Group 5. Read the member data for Group 5, by sending the command [RDG5]. The system will return feedback as follows:
[G5=C2C4C6]
The feedback shows G5 (Group 5) and then the cards that make up Group 5. In this case, Group 5 includes C2, C4 and C6.
7.3.SUMMARY OF COMMANDS Card Commands
1) [VER] | Display software version |
2)[C] Display card status
3) | [CnS] | Save card settings |
4) | [?] | Display system cards |
5) | [?C] | Display card information |
6) | [STA1] | Enable auto feedback |
7) | [STA0] | Disable auto feedback |
8) | [ +O ] | Increment output volume |
9) | [ | Decrement output volume |
10) | [ +I ] | Increment input gain |
11) | [ | Decrement input gain |
19 |
12) | [ + ] | Increment value by one |
13) | [ - ] | Decrement value by one |
14) | [SEL] | Select input level to adjust |
| [SELm] | Select output volume to adjust |
15) | [VLO] | Set output volume level |
16) | [VLI] | Set an input level |
17) | [RUP] | Ramp volume UP to 32 |
18) | [RUP=] | Ramp volume UP to a value |
19) | [RDN] | Ramp volume DOWN to 1 |
20) | [RDN=] | Ramp volume DOWN to a value |
21) | [RAMP] | Return ramp rate |
22) | [RAMP=] Set ramp rate | |
23) | [RST] | Stop ramping |
24) | [CLR] | Reset card to default values |
25) | [ONm] | Select the active input |
26) | [ON] | Enable output |
27) | [OFF] | Disable output |
28) | [MUT0] | Enable output |
29) | [MUT1] | Disable output |
30) | […S] | Save command configuration |
31) | […F] | Display feedback upon sending |
32) | […P] | Set the path, preload for [SW] |
33) | [SW] | Switch preloaded output buffer |
34) | [TEST] | Perform board memory test |
35) | [FBD] | Enable/disable feedback delay |
36) | [RSI] | Reset Card IDs to defaults |
37) | [SIDn] | Set all Card IDs |
38) | [SIDnCi] | Set one Card ID |
39) | [SID+] | Set all Card IDs to an offset |
40) | [RSN] | Display card slot number |
41) | [HELP] | Display available commands |
19