MULTITASKER™
DIAGRAM 3: JUMPER SETTINGS
L1E L7 L2E L8
P23 | L1E L7 L2E L8 |
| P23 |
P24
R7 | P24 | |
R1E | ||
R7 | ||
| ||
R8 | R1E | |
R8 | ||
R2E | ||
R2E |
Default jumper settings shown.
INPUT 1 INPUT 2
INPUT 3 INPUT 4
INPUT 5 INPUT 6
INPUT 7 INPUT 8
OUTPUT
The
The internal input is configured as input 7 or input 8. Only one of two internal inputs is used at a time and it depends on how the jumpers on the Expansion are set. In order to use one of the internal inputs, one of the external inputs (7 or 8) cannot be used.
Setting Jumpers:
1)As an Expansion card: set P13 as port 7 (L1E and R1E) or port 8 (L2E and R2E).
2)As a Master card: set jumpers on P23 and P24 as described below.
If the Expansion card's jumpers on P13 are set on L1E and R1E, the Master card must select internal input 7 on P23 (L1E) and P24 (R1E).
If the Expansion card's jumpers on P13 are set on L2E and R2E, the Master card must select internal input 8 on P23 (L2E) and P24 (R2E).
Note: The
7 |
7