MULTITASKER™
42.[RAMP=x]
This command sets the ramp rate for 32 steps. The settings range from 4 to 18 seconds, in
Command Format: [RAMP=xCnUi]
x | = | Rate in Seconds | |
|
| 4 | = 0.13 seconds/step |
|
| 6 | = 0.19 seconds /step |
|
| 8 | = 0.25 seconds /step |
|
| 10 | = 0.31 seconds /step |
|
| 12 | = 0.38 seconds /step |
|
| 14 | = 0.44 seconds /step |
|
| 16 | = 0.50 seconds /step |
|
| 18 | = 0.56 seconds /step |
Cn | = Card ID (n = # from 1 to max slots) | ||
Ui | = | Unit ID (i = # from 0 to 9) | |
Example:
There is an
0.50seconds per step. Confirm the setting by sending the command [RAMPC5] and receiving the feedback:
RAMP TIME = 16 SECONDS
43.[MUT0]
This command turns on the all the outputs without changing the input port selected and without changing any volume settings.
Command Format: [MUT0CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [MUT0C4] to enable the outputs for the card in slot 4.
44.[MUT1]
This command turns off all the outputs without changing the input port selected and without changing any output volume settings.
Command Format: [MUT1CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [MUT1C4] to mute all the outputs for the card in slot 4.
45.[MATmXy]
The matrix command allows the matrix switcher to be setup for different matrix sizes. The following tables show how the inputs and outputs will be configured when the matrix is changed. The input and output layouts are as viewed from the front of the card.
Example:
In the 4x4 configuration, when Input 1 is connected to Output 4, the entire channel, 1a and 1b, will be switched to outputs 4a and 4b respectively.
Command Format: [MATmXyCnUi]
m = number of inputs (m = 8, 4 or 2)
y = number of outputs (y = 8, 4 or 2)
Cn = Card ID (n = slot # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
| 8 x 8 | |
INPUTS |
| OUTPUTS |
1 |
| 1 |
2 |
| 2 |
3 |
| 3 |
4 |
| 4 |
5 |
| 5 |
6 |
| 6 |
7 |
| 7 |
8 |
| 8 |
21 |