MULTITASKER
27.[OUTmmS]
This command displays the input number that is connected to an output if the output is enabled.
Command Format: [OUTmmSCn]
mm= Output Number (mm = # from 01 to 64) Cn = Card ID (n = slot # from 1 to max slots) Example 1:
There is an
[1C08]
28.[…P] – Path
This command will set the path for the output, but it is not active until the switch command [SW] is executed. Commands ending in "P" are not executed immediately. The path for multiple cards or the same card can be preset.
Example 1:
Switch Input 1 to Output 2, and switch Input 2 to Output 4 simultaneously with the following commands:
[I1O2C8P]
[I2O4C8P]
[SW]
29.[SW] – Switch
The Switch command immediately connects inputs and outputs that were previously set with the Path command. All cards in the system that were preset with the Path command will switch at the same time, not only
See the [PATH] command for examples.
30.[SEL]
This command selects the path to adjust the input volume. Send this command first, then use the [+] and
CAUTION: This adjustment is on the input, NOT the output. If Input 1 is connected to more than one output, adjusting Input 1’s volume will affect all the outputs connected to Input 1.
Command Format: [SELmmCn]
mm = Input no. (mm = # from 01 to 64)
Cn = Card ID (n = slot # from 1 to max slots)
Example:
There is an
1.[SEL02C8]
The current volume level is 10.
2.[ - ] [ - ] [ - ]
The level is now 7 and is too quiet.
3.[ + ] [ + ] [ + ] [ + ] [ + ] [ + ] [ + ] [ + ]
The level is 15 and no further adjustments are required.
NOTE: The above example shows a typical adjustment using single steps to increase and decrease the volume. The volume can also be adjusted in steps larger than one. See the [+] and
18 |