MULTITASKER
Example 1:
Command = [ON1C8]
Feedback = | (ON11110000…C08) |
ON | = Output status |
11110000 = Output ON/OFF
Outputs
C08 = Card slot number
Example 2:
Command = [MODE=0C8]
Feedback = (MM0C08)
MM= Blocking mode
0 =
C08 = Card slot number
15.[STA0]
This command disables automatic feedback from the card and front panel. The command affects any card with
Command Format: [STA0]
16.[...F] – FEEDBACK
After processing a command, an OK or [ERR001] will be returned as feedback if "F" is included at the end of a command string.
Send command with AFB on and without “F”: [I1O*C8] [ ]
Send command with AFB off and without “F”: [I1O*C8]
Send command with AFB on and with “F”: [I1O*C8F] OK
Send command with AFB off and with “F”: [I1O*C8F] OK
MATRIX SETUP
The matrix setup commands define the size and configuration of a matrix. Several matrices can be defined for a single engine, although only one is typically used.
17.[MAT]
This command sets the matrix configuration for the matrix engine. The properties shown in
Command Format:
[MATj;mm;ww;xx;yy;kk;ll;CnS]
j= Matrix ID (j = # from 1 to 9) mm = Inputs
ll = Channel spacing
(The
S = Save
This property saves the configuration to memory, and allows the configuration to be recalled any time, even after
Adding the “S” to the command will also make the matrix configuration the default at
In order to change the
14 |