MULTITASKER
CARD CONTROL
Card control commands allow the main functions of the card to be executed over the
20.[ONmm]
This command turns on a single output.
Command Format: [ONmmCn]
mm= Output Number (mm = # from 01 to 64) Cn = Card ID (n = slot # from 1 to max slots) Example:
There is an
21.[ON]
This command turns on all outputs.
Command Format: [ONCn]
Cn = Card ID (n = slot # from 1 to max slots)
Example:
There is an
22.[OFFmm]
This command turns off a single output.
Command Format: [OFFmmCn]
mm= Output Number (mm = # from 01 to 64) Cn = Card ID (n = slot # from 1 to max slots) Example:
There is an
23.[OFF]
This command turns off all outputs.
Command Format: [OFFCn]
Cn = Card ID (n = slot # from 1 to max slots)
Example:
There is an
24.[ImmOxx]
This command connects a single input to a single output.
Command Format: [ImmOxxCn]
mm= Input
Cn = Card ID (n = slot # from 1 to max slots) Example:
Connect Input 22 to Output 32 of C8 by sending [I22O32C5].
25.[ImmO*]
This command connects a single input to all the outputs.
Command Format: [ImmO*Cn]
mm = Input
Cn = Card ID (n = slot # from 1 to max slots)
Example:
Connect Input 7 of C8 to all the outputs of C8 by sending [I07O*C8].
26.[INmmS]
This command displays a list of all enabled outputs that are connected to the specified input. Disabled outputs are not listed.
Command Format: [INmmSCn]
mm= Input Number (mm = # from 01 to 64) Cn = Card ID (n = slot # from 1 to max slots) Example 1:
There is an
[1,2,3,4C08]
17 |