Altinex MT107-103 Ver, Sio, Clr, Test, Help, Fbd, Afb, Ack, Mat, Mode, Off, Sel, Vol, Sdi, Sdo

MULTITASKER

7.3SUMMARY OF COMMANDS Basic Commands

1)	[VER]	Display software version
2)	[C]	Display card status (short)
3)	[CnS]	Save all card settings
4)	[…S]	Save one command setting
5)	[SIO]	Display card status (long)
6)	[CLR]	Reset card to defaults
7)	[TEST]	Test internal memory ICs
8)	[HELP]	Display help file
Feedback Control
9)	[FBD]	Feedback delay on/off
10)	[?]	Display system information
11)	[?C]	Display card information
12)	[AFB]	Enable/disable feedback
13)	[ACK]	Display acknowledge, [ ]
14)	[STA1]	Enable auto-feedback
15)	[STA0]	Disable auto-feedback
16)	[...F]	Display OK after command
Matrix Setup
17)	[MAT]	Set matrix configuration
18)	[MjCn]	Select matrix configuration
19)	[MODE]	Turn blocking on/off

Card Control
20)	[ONmm]	Turn on one output
21)	[ON]	Turn on all outputs
22)	[OFFmm]	Turn off one output
23)	[OFF]	Turn off all outputs
24)	[ImmOxx]	Connect one-in to one-out
25)	[ImmO*]	Switch one-in to all-out
26)	[INmmS]	Display outputs on input
27)	[OUTmmS]	Display input on output
28)	[…P]	Preload path for [SW]
29)	[SW]	Switch preloaded path
30)	[SEL]	Set path for volume adjust
31)	[+]	Increment volume
32)	[-]	Decrement volume
33)	[VOL]	Set absolute volume
34)	[SDI]	Input signal detect
35)	[SDO]	Output signal detect
ID Commands
36)	[RSI]	Reset Card IDs to default
37)	[SIDn]	Set all Card IDs
38)	[SIDnCi]	Set one Card ID
39)	[SID+]	Set all Card IDs to an offset
40)	[RSN]	Display card slot number
Group Commands
41)	[WR]	Add card(s) to a group
42)	[RMC]	Remove card(s) from group
43)	[RMG]	Delete group
44)	[RD]	Display group members

400-0367-005 23