Allied Telesis AT-8000GS/24, AT-8000GS/POE Installing the Device, Desktop or Shelf Installation

Page 32

Chapter 2: Installation

Installing the Device

Desktop or Shelf Installation

The device can be installed on a flat surface or mounted in a rack. This section includes the following topics:

“Desktop or Shelf Installation” on page 32

“Rack Installation” on page 32

When installing the switch on a desktop or shelf, the rubber feet included with the device should first be attached. Attach these cushioning feet on the bottom at each corner of the device.

Ensure the surface is be able to support the weight of the device and the device cables. To install the device on a surface, perform the following:

1.Attach the rubber feet on the bottom of the device. The following figure illustrates the rubber feet installation on the device.

Figure 1: Installing Rubber Feet

2.Set device down on a flat surface, while leaving 2 inches on each side and 5 inches at the back.

3.Ensure that the device has proper ventilation by allowing adequate space for ventilation between the device and the objects around the device.

Rack Installation The device can be mounted in an EIA standard-sized, 19-inch rack, which can be placed in a wiring closet with other equipment. To install the device the mounting brackets must first be attached to the device’s sides.

32

Image 32

Contents Installation Guide Page Preface Safety Symbols Used in this Document Symbol Meaning DescriptionWhere to Find Web-based Guides Management Software Updates Contacting Allied TelesisContent Page Overview ChapterAT-8000GS Switch Series Features ˆ PVEIeee Standards ˆ Ieee 802.3 10Base-T ˆ Ieee 802.3u 100Base-TXˆ 2 Stacking Ports Two Hdmi connector stacking ports Model DescriptionsAT-8000GS/24POE Gigabit Ethernet Switch Front Panel 24POEAT-8000GS/48 Gigabit Ethernet Switch Front Panel Port Descriptions 10/100/1000 Base Gigabit Ethernet Ports SFP PortRJ-45 Console Port ATI Reference Vendors and PartsLED Definitions System LEDsStacking Port LEDs IndicationLED Indication Description SYSLED RJ-45 Port LEDs on AT-8000GS/24 & AT-8000GS/48 LED Description LED Indication Functional DescriptionLED FDX PortLED Link POE RJ-45 Port LEDs AT-8000GS/ 24POEDescription Indication Green Off No link is established on the port Stacking Port LEDs Overview Installation Reviewing Safety Precautions AT-8000GS Series Gigabit Ethernet Switch Installation Guide Please return damaged units for servicing Preparing for Installation Installation PrecautionsPackage Contents Site Requirements UnpackingPage Installing the Device Desktop or Shelf InstallationAttaching the Mounting Brackets AC Power Connection Connecting the DeviceConnecting Switch to a Terminal Stacking Stacking Overview Stacking Ring TopologyStacking Members Unit ID Removing Replacing Stacking Chain TopologyStacking Exchanging Stacking Members Configuring Stacking Page Stacking Initial Configuration Configuration Overview Configuration Static IP Address and Subnet MaskIllustrated in the following example Device not operating correctly TroubleshootingCannot connect using Telnet, Web browser, or Snmp software Forgot or lost the password Technical Specifications Physical SpecificationsWeight Environmental SpecificationsPower Specifications Power Supply for Non-POE modelCertifications Cable, Port, and Pinout InformationPin Connections for the 10/100/1000 Ethernet Interface RJ-45 Pin AllocationAppendix a Technical Specifications

Related manuals

Manual 9 pages 17.85 Kb