Allied Telesis X600-24TS-POE+, x600-48Ts, x600-24Ts/XP, x600-24Ts-POE Installing AT-StackXG Module

Installing the

AT-StackXG

Module

x600 Layer 3 Gigabit Ethernet Switch Installation Guide

To install the AT-StackXG module, perform the following procedure:

1. Remove the module from the shipping package.

Note

Store the packaging material in a safe location. You must use the original shipping material if you need to return the unit to Allied Telesis.

2.Remove the blank panel from the expansion slot on the rear panel of the switch by loosening the two captive screws on the panel with a cross-head screwdriver.

1241

Figure 36. Removing the Blank Panel from the Expansion Slot

Note

All X600 Series Layer 3 Switch models are shipped from the factory with a Blank Panel installed in the rear panel Expansion Slot except for the x600-48Ts/XP, which is shipped with an AT-LBM (Loop Back) module instead.

Note

Do not remove the blank panel from the chassis until you are ready to install a module. An open slot allows dust to enter the unit and reduces proper airflow and cooling.

3.Align the edges of AT-StackXG module with the guides in the slot and carefully slide the module into the chassis until it is flush with the rear panel of the chassis, as shown in Figure 37 on page 76. Light pressure may be needed to seat the module on the connector on the rear panel of the chassis.

75