Allied Telesis x600-48Ts, x600-24Ts/XP manual Overview Preparation Installing the AT-StackXG Module

Contents
VCS Stacking Module	48
AC Power Connector	49
Chapter 2: Virtual Chassis Stacking	51
VCStackTM Introduction	52
Features of VCStacking	52
The Physical Stack	52
Resiliency Link	54
VCStack Recovery States	54
Resiliency Link Configurations via Switch Ports	56
Resilient Stacked Topology	57
Stack Formation	58
The Role of the Stack Master	58
Stack Member Failure and Recovery	61
VCS Failure Recovery	62
Stack Maintenance	63
Chapter 3: Installing the Hardware	65
Reviewing Safety Precautions	66
Unpacking a Switch	69
Installing the Power Cord Retaining Clip	70
Installing the Switches in an Equipment Rack	71
Resetting the Switch	73
VC Stacking Module Installation	74
Overview	74
Preparation	74
Installing the AT-StackXG Module	75
Chapter 4: Cabling the Network Ports	79
Twisted Pair and Fiber Optic Specifications	80
Twisted Pair Cable Specifications	80
SFP/XFP Transceiver Specifications	81
Installing SFP/XFP Transceivers	82
Installing an SFP Transceiver	82
Installing an XFP Transceiver	85
Cabling the 10/100/1000Base-T and Fiber Optic Ports	87
Powering on a Switch	88
Starting a Local Management Session	89
Warranty Registration	91
Chapter 5: Troubleshooting	93
Power LED is Off	94
Twisted Pair Port Link LED is Off	95
SFP or XFP LED is Off	96
Transceiver is Installed but the Status is “Not Present”	97
System Fault LED is Blinking	98
System Fault LED is Steadily On	99
Cannot Establish a Local (Out-of-Band) Management Session	100
Switch Functions Intermittently	101
Issues with Virtual Stacking Chassis Configuration	102
Appendix A: Technical Specifications	103
Physical Specifications	103
Environmental Specifications	104
Power Specifications	104
Certifications	105
RJ-45 Twisted Pair Port Pinouts	106
RJ-45 Style Serial Terminal Port Pinouts	108
AT-RPS310417-pin Connector Pinouts	108
AT-RPS320421-pinD-combo Port and Connector Pinouts	110

6