10 | Patch Release Note |
Features in SB251-01
Patch file details are listed in Table 8:
Table 8: Patch file details for Patch
Base Software Release File | |
|
|
Patch Release Date | |
|
|
Compressed Patch File Name | |
|
|
Compressed Patch File Size | 71828 bytes |
|
|
PCR: 02555 | Module: SWI | Network affecting: No |
Layer 2 filtering is now working correctly.
PCR: 02561 | Module: SWI | Network affecting: No |
32 bit counters now only show 8 bit contents.
PCR: 02563 | Module: SWI | Network affecting: No |
The IPM (Layer 3 Multicasting table) now updates correctly to add or delete the ingress linecard to control blade ports, and the control blade to egress linecard ports when updating forwarding.
PCR: 02568 Module: CORE | Network affecting: No |
The ENABLE SYSTEM SECURITY_MODE command was enabling the system security mode, but after the switch was restarted the system security mode was disabled again. Also, when NVS was
PCR: 02576 | Module: SWI | Network affecting: No |
When the DISABLE SWITCH PORT FLOW=PAUSE command was executed on a port or ports, they would still appear to be enabled at a higher level. This issue has been resolved.
PCR: 02396 Module: DHCP | Network affecting: No |
DHCP RENEW request messages are now unicast (as defined in the RFC), not broadcast.
PCR: 02575 | Module: SWI | Network affecting: No |
VLAN tagged multicast packets were incorrectly being sent over untagged
VLAN interfaces. This issue has been resolved.
PCR: 02574 Module: DVMRP | Network affecting: No |
Some change actions, and the resending of prune messages were not operating correctly. This issue has been resolved.
PCR: 02582 | Module: SWI | Network affecting: No |
Pause flow control is now disabled by default on all ports. This improves performance of the switch when it is congested.
Patch