6 | Patch Release Note |
PCR: 03243 | Module: SWI | Level: 2 |
After autonegotiation had finished between two ports, the port on the SwitchBlade would not show link up status when the SHOW SWITCH PORT command was executed. The autonegotiation process is now restarted if autonegotiation is completed and the link is shown as down.
PCR: 03249 | Module: SWI | Level: 4 |
The LEDs on line cards now continue to flash when activity exists. Previously if a cable was connected and disconnected to Line 48 and G8 ports, with traffic being transmitted from the other end, then the LED would stop flashing, even when there was activity on the link.
Features in SB251-03
Patch file details are listed in Table 6.
Table 6: Patch file details for Patch
Base Software Release File | |
|
|
Patch Release Date | |
|
|
Compressed Patch File Name | |
|
|
Compressed Patch File Size | 68784 bytes |
|
|
Patch
PCR: 02361 | Module: SWI | Level: 4 |
The SwitchBlade mirror port field on the second instance of a switch chip was displaying as though it was the first instance. For example, if 2.26 was configured as the mirror port, the GUI mirror object would return 2.2. The first chip instance was not affected. This issue has been resolved.
PCR: 02527 | Module: TCP | Level:3 |
TCP6 did not send a TCP Reset message under some circumstances, for example when the Telnet server was disabled. This issue has been resolved.
PCR: 03025 | Module: GUI | Level:2 |
A buffer address was incrementing and not returning buffers for reuse when the command line interface was accessed via the GUI interface. This issue has been resolved.
PCR: 03055 | Module: SWI | Level: 4 |
If the SET SWITCH BLADE command was executed with the default settings, then the default settings were added to the configuration file. The SET SWITCH BLADE settings are now only added to the configuration file if they differ from the default settings.
Patch