Allied Telesis SB251-08 manual PCR Module Firewall Network affecting No

Page 9

Patch SB251-08 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches

9

PCR: 03023

Module: SWI

Network affecting: No

The SET SWITCH PORT ACCEPTABLE command did not work correctly on all specified port numbers. This issue has been resolved.

PCR: 03028

Module: SWI

Network affecting: No

A warning message was generated when a slave line card was not initialised, and the configuration script was not loaded. This issue has been resolved.

PCR: 03030

Module: SWI

Network affecting: No

RIP was not operating correctly because a MAC address search returned the wrong port number. This issue has been resolved.

PCR: 03031

Module: FIREWALL

Network affecting: No

The ADD FIREWALL POLICY RULE command included an erroneous check on port ranges for non-NAT rules. This check is now restricted to NAT rules.

PCR: 03034

Module: SWI

Network affecting: No

Executing the SET IP INTERFACE and SET IPX INTERFACE commands on a SwitchBlade produced debugging output on the ASYN port. This issue has been resolved.

PCR: 03037

Module: QOS

Network affecting: No

A new value is now shown in the output of the SHOW QOS POLICY command. This is the value of the port bandwidth used when the default traffic class percentage bandwidth is set on a QoS Policy.

PCR: 03039

Module: SWITCH, IPG

Network affecting: No

Adding a layer 2 filter on a SwitchBlade did not block traffic to the end host as intended. This issue has been resolved.

PCR: 03043

Module: SWITCH

Network affecting: No

On a SwitchBlade, PCI errors occurred periodically after a line card was hotswapped. This issue has been resolved.

PCR: 03047 Module: CORE

Network affecting: No

The board revision number for the slave control blade was erroneously set to the same number as the master control blade. This issue has been resolved.

PCR: 03428

Module: STP

Network affecting: No

If a port belongs to an enabled STP instance, but the port has been disabled from STP operation with the DISABLE STP PORT command, the port will not respond to ARP requests. This patch implements a workaround that allows disabled STP ports to respond to ARP requests.

Patch SB251-08 for Software Release 2.5.1 C613-10361-00 REV H

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Introduction PCR Module SWI Level Features in SB251-08PCR Module STP, SWI Level Features in SB251-07Features in SB251-05 Features in SB251-06PCR Module SWI PCR Module SWI, Sysr LevelFeatures in SB251-04 Features in SB251-03 PCR Module TCP Level3PCR Module GUI Level2 PCR 03071 Module Core Level PCR Module CORE, SWI LevelPCR Module IPG, SWI Level PCR Module Firewall LevelPCR Module Switch Network affecting No Features in SB251-02PCR 02574 Module Dvmrp Network affecting No PCR Module SWI Network affecting NoPCR Module Firewall Network affecting No PCR Module SWITCH, IPG Network affecting NoPCR Module QOS Network affecting No PCR 03047 Module Core Network affecting NoFeatures in SB251-01 PCR 02568 Module Core Network affecting NoPCR 02396 Module Dhcp Network affecting No PCR Module Ospf Network affecting No AvailabilityPCR Module SWI Classifier Network affecting No PCR Module IPG, SWI Network affecting NoPatch Release Note
Top Page Image Contents