Spanning Tree Commands
get-st-bcfg
This command retrieves the Spanning Tree bridge parameters. If
Spanning Tree is disabled, no parameters will be retrieved.
get-st-pcfg
This command retrieves the Spanning Tree port parameter table. If
Spanning Tree is disabled, no parameters will be retrieved.
get-st-syscfg
This command retrieves the Spanning Tree state of all the ports.
set-br-prio
This command sets the Spanning Tree bridge priority of the Switch. priority is an integer in the range 0..65535.
set-br-maxage
set-br-maxage <maxage>
This command sets the Spanning Tree bridge MaxAge. This is the amount of time between Spanning Tree configuration messages. Note that maxage is in units of seconds in the range 6..40.
set-br-hellot
set-br-hellot <hello_time>
This command sets the Spanning Tree bridge Hello Time. hello_time is an integer in the range 1..10. Note that hello_time is in units of seconds.
set-br-fwdel
set-br-fwdel <forward_delay>
This command sets the Spanning Tree bridge Forward Delay. This controls the amount of time between the listening and forwarding Spanning Tree states, and is completely unrelated to the forwarding latency. Note that forward_delay is an integer in units of seconds in the range 4..30.