APC 78-10169-02 manual Monitoring with ICS System Manager, Modifying the Base Community String

Page 16

Chapter 2 Monitoring the System

Monitoring with ICS System Manager

•Number represents the target physical slot number (slots 1 through 8) of the SNMP request.

Note All SNMP requests with a composite community string of @SLOT9 or higher are directed to the SSP, which determines the proper SNMP message destination.

For example, assuming that a particular SNMP request needs to reach an MRP card in slot 3, the following composite community string could be used:

ICS7750@SLOT3

where ICS7750 represents the standard system get or set community string.

Modifying the Base Community String

You can modify the default read-only and read-write community strings with

ICS System Manager. (Refer to the ICS System Manager online help.)

Monitoring with ICS System Manager

ICS System Manager monitors the Cisco ICS 7750 as follows:

•ASIs and MRPs—ICS System Manager provides information about trunk errors, interface errors, memory usage, buffer failures, buffer creation, and ASI and MRP usage.

•SSP—ICS System Manager provides information about SNMP, IP, Internet Control Message Protocol (ICMP), TCP errors, UDP errors, as well as information about SSP usage.

Note For information about monitoring individual Cisco IP Phones or the lines connecting those devices to the Cisco ICS 7750, refer to the “Admin Serviceability Tool” chapter in the Cisco CallManager Serviceability Administration Guide. For additional information on monitoring the system with ICS System Manager, refer to the ICS System Manager online help.

 

Cisco ICS 7750 Administration and Troubleshooting Guide

2-16

78-10169-02 Rev. B0

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Monitoring the System Alarms Alarm NotificationHow to Access Log Messages Alarm LevelsLogging Handling Log Messages with ICS System Manager How to Read Log MessagesSaving Log Messages to a Syslog Server Element Example Format Description StringFacilities Severity LevelsKeyword Description Keyword Level Description Syslog DefinitionHow to Change the Log Configuration Configuring the Syslog Daemon on Unix Syslog Servers Default Log ConfigurationConfiguration Parameters Default Setting Task Command Changing Syslog Server LoggingSnmp Basics Snmp ComponentsMajor Components of SNMP-Managed Networks Using Snmp with MIB Variables Snmp Management Information Base Operation Description Snmp NetworkUnderstanding Traps Supported MIBsUnderstanding Community Strings Cisco ICS 7750 TrapsMonitoring with ICS System Manager Modifying the Base Community StringMonitoring with CiscoWorks2000 Using CiscoWorks2000 for Network ManagementCiscoWorks2000 Applications Evaluating System Performance Monitoring with Cisco IOS SoftwareSnmp and the CiscoWorks2000 Interface Evaluating Reachability and Response Times In-Band Versus Out-of-Band MonitoringEvaluating Traffic Loads Using show Commands Common show CommandsSearching and Filtering Output of show Commands Connecting and Powering Up the UPS ComponentsMonitoring a UPS Through a Serial Connection on Start Programs APC Card Management Wizard Check the Start a Web browser when finished check box Choose Start Run SetUPSHostName -HostName Name Verify that the Cisco ICS 7750 can communicate with the UPS 78-10169-02 Rev. B0
Top Page Image Contents