Chapter 2 Monitoring the System
Monitoring a UPS
Searching and Filtering Output of show Commands
In Cisco IOS software Release 12.0(1)T or later, you can search and filter the output for show commands. This functionality is useful when you need to sort through large amounts of output, or if you want to exclude output that you do not need to see.
To use this functionality, enter a show command followed by the “pipe” character (), one of the keywords begin, include, or exclude, and an expression that you want to search or filter on:
command {begin include exclude}
The following is an example of a show interface command that provides information only about lines where the word “protocol” appears:
Cisco ICS 7750# show interface include protocol
FastEthernet0/0 is up, line protocol is up
Serial4/0 is up, line protocol is up
Serial4/1 is up, line protocol is up
Serial4/2 is administratively down, line protocol is down
Serial4/3 is administratively down, line protocol is down
For more information on search and filter functionality, refer to the “Basic
Monitoring a UPS
This section explains how to monitor an APC
Connecting and Powering Up the UPS Components
Complete the following steps to set up the components:
Step 1 Connect the UPS to the SAP card COM1 port or to an Ethernet switch that is connected to the Cisco ICS 7750. Refer to the “SAP Card COM Ports” section in the “Installing the Cisco ICS 7750” chapter of the Cisco ICS 7750 Hardware Installation Guide.
|
| Cisco ICS 7750 Administration and Troubleshooting Guide |
|
|
|
|
| ||
|
|
| ||
|
|
|