Linksys SGE2000 manual Back Panel, Uplink Ports, Power Port

Uplink Ports

The Switch is equipped with 4 mini-GBIC uplink ports.

GBIC1-4 The Switch provides four mini-GBIC ports. The mini-GBIC port is a connection point for a mini-GBIC expansion module, so the Switch can be uplinked via fiber or copper to another switch. Each mini-GBIC port provides a link to a high-speed network segment or individual workstation at speeds of up to 1000Mbps.

Use the Linksys MGBT1, MGBSX1, or MGBLH1 mini-GBIC modules with the Switch. The MGBSX1 and the MGBLH1 require fiber cabling with LC connectors, while the MGBT1 requires a Category 5e Ethernet cable with an RJ-45 connector.

The Back Panel

The power port is located on the back panel of the Ethernet switch.

1 2 3

DC INPUT FOR REMOTE

POWER SUPPLY SPECIFIED

IN MANUAL +12V, 7.5A

Power Port

The 100-240 VAC power cord is connected to the Power port.

CAUTION: Only use the power cord that is supplied with the Ethernet switch. The unit may be damaged if the incorrect power cord is used.

Linksys One Ready Communications Solution

2

Chapter

Power Port. The Power port is where you will

1connect the power cord. For more details, refer to

”Power Port,” on page 6.

Console Port. The Console port is where you can connect a serial cable to a PC’s serial port for

2configuration. For more details, refer to ”Console Port,” on page 7.

RPS Port. Redundant Power Supply (RPS) port. For

3more details, refer to ”RPS Port,” on page 7.

6	Chapter 2: Getting to Know the Switch
	The Back Panel