Linksys SGE2000 manual Wall-Mount Placement

Page 14

3.Place a rack mount bracket next to the spacer and reinstall the four screws (removed in step 1).

4.Repeat steps 2 through 3 for the other side of the Ethernet switch.

5.Attach the Ethernet switch to the rack using the supplied screws.

Wall-Mount Placement

1.On one of the side corners, remove the four front screws on of the Ethernet switch. Retain the screws for re-installation.

NOTE: The Ethernet switch, shown below, is mounted with the ports located on top. When the switch is mounted to a wall, the ports can be oriented in any direction.

2.Place one of the supplied spacers on the side of the Ethernet switch so the four holes align to the screw holes.

3.Place a rack mount bracket next to the spacer and reinstall the four screws (removed in step 1). The wall mount brackets should point towards the bottom of the Ethernet switch.

4.Repeat steps 1 through 3 for the other corners of the Ethernet switch.

5.Attach the Ethernet switch to a wall with appropriate screws (not supplied).

CAUTION: Ensure that the Ethernet switch is securely attached to the wall.

Linksys One Ready Communications Solution

3

Chapter

10

Chapter 3: Connecting the Switch

 

Placement Options

Image 14
Contents Release Page Contents Web Utility Configuration Appendix E SpecificationsIntroduction What’s in this User Guide?Introduction Front Panel Getting to Know the SwitchOverview Front Panel LEDsSystem Status LEDs Reset Switch LAN PortsUplink Ports Power PortBack Panel Console Port RPS PortConnecting the Switch Before You Install the SwitchRack-Mount Placement Placement OptionsDesktop Placement Wall-Mount Placement Connecting the Cables Repeat steps 2 and 3 to connect additional devicesStacking Multiple Switches Stacking HighlightsConnecting Cabling for Stacking Interface, you can change the mode to standalone modeConsole Configuration Configuring the HyperTerminal ApplicationSet the serial port settings as follows Connecting to the Switch using Telnet or SSH Switch Main Menu System InformationManagement Settings Serial Port Configuration Chapter User & Password Settings Security Settings Chapter IP Configuration To change IP address configuration settings Chapter File Management Stack Configuration Restore System Default SettingsReboot System Back to main menuPort Configuration Help Viewing Online Help Web Utility ConfigurationAccessing the Web-based Utility Linksys Contact Information AppendixUAE Customer Site Survey ˆ No Uplink speed must be greater than 768 Kbps Limited Warranty Appendix C Limited Warranty EC Declaration of Conformity Europe Federal Communication Commission Interference StatementIndustry Canada Statement Specifications Vlan Radius DOS MAX Appendix Release