Linksys SGE2000 manual Restore System Default Settings, Reboot System, Stack Configuration

Page 32

Restore System Default Settings

To set the Ethernet switch back to the factory default settings, select Restore System Default Settings and press the Enter key. You will be asked if you want to continue. Press the y key to restore the default settings, or press the n key to cancel.

NOTE: Restoring default settings from the console, web, or Linksys One portal interfaces resets all values except stacking configuration (stacking mode, stacking ports, and auto-numbering settings are NOT reset). To reset stacking configuration, use the hardware reset button on the front of the Ethernet switch.

Reboot System

Select Reboot System and press the Enter key if you want to restart the Ethernet switch. You will be asked if you want to continue. Press the y key to reboot the Ethernet switch, or press the n key to cancel. After the Ethernet switch has rebooted, the Switch Main Menu screen will appear.

Stack Configuration

Select Stack Configuration to specify the Stack ID for the Ethernet switch. By default, ID numbers are automatically assigned to each device.

Back to main menu

Select Back to main menu and press the Enter key if you want to return to the Switch Main Menu screen.

Port Status

The Port Status screen displays the port connection status.

To view the status of the ports:

1. On the Switch Main Menu screen, select Port Status.

Linksys One Ready Communications Solution

4

Chapter

TIP: Use the up or down arrow keys to scroll through all the ports on the Ethernet switch.

28

Chapter 4: Console Configuration

 

Configuring the Switch through the Console or Telnet Interface

Image 32
Contents Release Page Contents Web Utility Configuration Appendix E SpecificationsIntroduction What’s in this User Guide?Introduction Getting to Know the Switch OverviewFront Panel Front Panel LEDsSystem Status LEDs Reset Switch LAN PortsUplink Ports Power PortBack Panel Console Port RPS PortConnecting the Switch Before You Install the SwitchRack-Mount Placement Placement OptionsDesktop Placement Wall-Mount Placement Connecting the Cables Repeat steps 2 and 3 to connect additional devicesStacking Multiple Switches Stacking HighlightsConnecting Cabling for Stacking Interface, you can change the mode to standalone modeConsole Configuration Configuring the HyperTerminal ApplicationSet the serial port settings as follows Connecting to the Switch using Telnet or SSH Switch Main Menu System InformationManagement Settings Serial Port Configuration Chapter User & Password Settings Security Settings Chapter IP Configuration To change IP address configuration settings Chapter File Management Restore System Default Settings Reboot SystemStack Configuration Back to main menuPort Configuration Help Viewing Online Help Web Utility ConfigurationAccessing the Web-based Utility Linksys Contact Information AppendixUAE Customer Site Survey ˆ No Uplink speed must be greater than 768 Kbps Limited Warranty Appendix C Limited Warranty EC Declaration of Conformity Europe Federal Communication Commission Interference StatementIndustry Canada Statement Specifications Vlan Radius DOS MAX Appendix Release